Zeiss Victory FL Operating instructions

Brand: Zeiss

Model: Victory FL

Type: Operating instructions

Page is loading ...

Carl Zeiss Sports Optics

Gebrauchshinweise

Instructions for use

Mode d’emploi

Istruzioni d’impiego

Modo de empleo

Bruksanvisning

Informacje dotyczące użytkowania

Инструкция по применению

Használati utasítás

ZEISS VICTORY 32 T* FL

ZEISS. PIONIER SEIT 1846.

1375-600 / 03.2014

ZEISS VICTORY

“This product may be covered by one or more of the following

United States patents: US6542302, US6816310, US6906862”

www.zeiss.de/sports-optics

Carl Zeiss

Sports Optics GmbH

Carl Zeiss Group

Gloelstrasse 3 – 5

35576 Wetzlar

32 T* FL / 42 T* FL / 56 T* FL

Page is loading ...

4 5

INSTRUCTIONS FOR USE

Congratulations on your outstanding new binoculars. Enjoy the impressive experience of

undistorted image reproduction which is distinguished by perfect brilliance and excellent

colour accuracy.

ZEISS brand products are characterised by outstanding optical performance, accurate

processing and long durability.

Please observe the following instructions for use, so that you enjoy optimum use of your

product and it can be a faithful companion to you for many years.

Viewing with and without glasses

If you do not wear glasses when viewing, use the binoculars with the eyecups extended (Fig.

1/A). To do this, turn the eyecups upwards to the top click stop position by turning them to the

left (counter clockwise). The eyecups can be set to four click stop positions – the positions at

the top and bottom and two intermediate positions (Fig. 2). These adjustment options permit

the distance from the exit pupil to be varied according to the speciﬁc requirements of each user.

If you wear glasses when viewing, turn the eyecups to the right (clockwise) to the lowest click

stop position as shown in Fig. 1/B.

Cleaning and changing the eyecups

The eyecups (complete modules) can be removed from the binoculars for cleaning or exchange.

Turn out the eyecup counter clockwise to the stop, then unscrew it completely via the thread

(continue to turn in the same direction). After cleaning or exchange, turn the eyecup clockwise to

the lowest click stop position. Then attach the module to the binoculars, through the rubber edge

of the eyepiece tube, turn it in clockwise as far as it will go and tighten it.

Adjustment of the interpupillary distance

Adjust the two barrels relative to each other about the central axis until you see one circular ﬁeld

of view when viewing with both eyes.

Focusing

The binoculars have a centre focusing mechanism (focusing knob Fig. 3/C) and a dioptre

adjustment wheel. Dioptre adjustment is activated by pulling the focusing knob (Fig. 3/C)

upward.

For focusing, close your right eye and focus the image in the left barrel using the centre

focusing mechanism (Fig. 3/C). Then close your left eye – and if necessary – adjust the focus

in the right barrel using the dioptre adjustment wheel.

The dioptre adjustment wheel is provided with a scale (visible when the focusing knob has been

pulled out, Fig. 3), the signs “+” and “–”, and a click stop in the zero position (0 D). The

graduation lines of the scale are used for orientation (setting the dioptre adjustment for different

users).

After completion of this procedure, push the focusing knob back in all the way.

Note: Always use the same object to focus on both images!

For subsequent focusing on varying distances, use the focusing knob only (Fig. 3/C). When the

long ridge of the focusing knob coincides with the arrow on the bridge (Fig. 3/D), the binoculars

have been set to inﬁnity. This only applies if the dioptre adjustment mechanism has snapped in

at the zero position (0 D).

Mounting the carrying strap and the protective covers

The carrying strap, the rainguard and the protective caps for the objective lens are provided in the

packaging. Attach the carrying strap to the eyelets pro-vided on the binoculars and mount the

rainguard on the strap as shown in Figs 4 + 5.

Note: Simply thread the carrying strap through the eyelets on the rainguard.

Before mounting the carrying strap as shown in Fig. 5, adjust the length of the strap as required

by loosening or tightening it accordingly using the clip.

The rain guard needs only to be attached on one side; however, it can be attached to both sides.

Use of the eyepiece cap

The eyepiece cap is held on the eye cup with a snap latch.

Remove the eyepiece cap with your index ﬁngers before using the binoculars.

The eyepiece cap should be reattached after using the binoculars to protect the eyepiece.

The protective caps for the objective lens are attached to the binoculars as shown in Fig. 6.

Mounting on a tripod

The binoculars of the ZEISS VICTORY FL series can be mounted on any commercial camera tripod

using the ZEISS universal tripod adapter for binoculars.

• Cat. No.: ZEISS Alu tripod kit 1778-480

• Cat. No.: ZEISS tripod adapter for binoculars 52 83 87

6 7

Care and maintenance

ZEISS binoculars need no special care or maintenance. Do not wipe off coarse dirt particles (e.g.

sand) from the lenses, but blow them off or remove them with a soft brush.

Fingerprints on the lens surfaces may affect them in the course of time. The easiest way to keep

the lenses clean is by breathing on them and wiping with a soft optical cleaning cloth or optical

cleaning paper. To avoid a possible fungal coating which is common in the tropics, store the

optics in a dry place and always ensure good aeration of the lens surface.

Warning:

Do not under any circumstances look through the binoculars at the sun or laser light sources!

Serious eye injury may otherwise result.

Accessories for ZEISS VICTORY binoculars T* FL

Alu tripod kit

incl. Video head an carrying strap

1778-480

Binoﬁx Tripod ﬁxture

suitable for all binocular models

52 83 87

Air Cell carrying strap, air cushioned

for ultra-high carrying comfort.

Attaches quickly with quick release mechanisms.

52 91 13

Attachment for magniﬁcation 3x12 Mono

for 3 times extra power

52 20 12

Adapter for ZEISS VICTORY 32 T* FL /

42 T* FL / 56 T* FL

52 83 77

Accessories are not included in delivery!

Subject to changes in design and scope of delivery as a result of ongoing technical development.

Technical data

ZEISS VICTORY

8x32 T* FL

ZEISS VICTORY

10x32 T* FL

ZEISS VICTORY

7x42 T* FL

ZEISS VICTORY

8x42 T* FL

ZEISS VICTORY

10x42 T* FL

ZEISS VICTORY

8x56 T* FL

ZEISS VICTORY

10x56 T* FL

Magniﬁcation 8x 10x 7x 8x 10x 8x 10x

Objective lens diameter (mm) 32 32 42 42 42 56 56

Field of view at 1000 m (m) 140 WW 120 WW 150 WW 135 WW 110 WW 130 WW 110 WW

Exit pupil (mm) 4 3.2 6 5.25 4.2 7 5.6

Shortest focusing distance (m) 2 2 2 2 2 3 3

Dioptre adjustment range ≥ +/– 4 dpt +/– 4 dpt +/– 4 dpt +/– 4 dpt +/– 4 dpt +/– 4 dpt +/– 4 dpt

PD from/to (mm) 52 – 74 52 – 74 54 – 76 54 – 76 54 – 76 55 – 76 55 – 76

Height with retracted

eyecup (mm)

117 117 152 161 161 188 188

Width with PD of 65 mm (mm) 116 116 128 128 128 145 145

Maximum width (mm) 129 129 138 138 138 158 158

Weight (g) 560 560 740 755 765 1220 1250

Waterproof in acc. with

DIN ISO 9022-8

● ● ● ● ● ● ●

Nitrogen ﬁlling

● ● ● ● ● ● ●

Subject to changes in design and scope of delivery as a result of ongoing technical development.

Page is loading ...

Zeiss Victory FL Operating instructions

Brand: Zeiss

Model: Victory FL

Type: Operating instructions

Download PDF

report

in other languages

italiano: Zeiss Victory FL Istruzioni per l'uso
français: Zeiss Victory FL Mode d'emploi
español: Zeiss Victory FL Instrucciones de operación
Deutsch: Zeiss Victory FL Bedienungsanleitung
русский: Zeiss Victory FL Инструкция по эксплуатации
polski: Zeiss Victory FL Instrukcja obsługi
svenska: Zeiss Victory FL Bruksanvisningar

Zeiss Victory FL Operating instructions

Zeiss Victory FL Operating instructions

in other languages

Related papers

Other documents