Dometic Electronic Water Valve
Replacment Instructions
1. Remove two wire terminals from
existing water valve.
2. Turn off power to fresh water
pump.
3. Remove existing valve from
base.
4. Assemble new valve with
bracket to the base using the
screws provided.
5. Connect water line to the new
supply hose.
Note: Use 1/2 in. x 1/2 in. coupling
supplied, if necessary.
6. Reconnect wire terminals to
water valve and turn power on.
Check for leaks and correct as
necessary.
Caution!
Turn off electrical power to toilet
before replacing water valve.
Dometic Corporation, Sanitation Division
13128 State Rt. 226, P.O. Box 38
Big Prairie, OH 44611 USA
1-800-321-9886 • Fax: 330-496-3097
www.Dometic.com
REVISION A
Form No. 600346456 8/17
©2017 Dometic Corporation
-
1
