Toro Adapter Kit, 2001 and Earlier 44" Snowthrowers to 2002 and Later GT Classic Garden Tractors Installation guide

Category
Wall & ceiling mounts accessories
Type
Installation guide
1
All Rights Reserved
Printed in the USA
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Adapter Kit
2001 and Earlier 44 Snowthrower to a 2002 and Later GT
Classic Garden Tractor
Part No. 105–1505
Form No. 3327–279
Installation Instructions
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Belt cover
Belt cover bracket
Bolts, 3/8 x 2 in.
Locknut, 3/8 in.
Washer
Hairpin cotter
1
1
2
2
2
2
Installing the belt cover
Installing the Bushing to Belt
Cover Bracket
1. Remove existing bolt, washer, spacer and locknut from
the existing belt cover bracket.
2. Install the bolt, washer, spacer and locknut to the new
belt cover bracket (Fig. 1).
m-5723
3
2
4
5
1
Figure 1
1. Belt cover bracket
2. Bolt
3. Locknut
4. Washer
5. Spacer
Installing the Belt Cover
Important These instructions are to be used when
installing your snowthrower. Refer to your operator
manual for complete snowthrower installation.
1. Park the machine on a level surface, disengage the
power take off (PTO), set the parking brake, and turn
the ignition key to off. Remove the key.
2. Install belt cover bracket to tractor frame with 2 bolts
(3/8 x 2 in.) and locknuts (3/8 in.) (Fig. 2).
2
1
3
m-5717
Figure 2
1. Belt cover bracket
2. Bolt, 3/8 x 2 in.
3. Locknut, 3/8 in.
2
3. Install belt cover to belt cover bracket and secure with
washers and hairpin cotters (Fig. 3).
Note: Install the belt cover after the belt has been
installed.
m–5720
4
2
1
3
Figure 3
1. Belt cover
2. Belt cover bracket
3. Washer
4. Hairpin cotter
  • Page 1 1
  • Page 2 2

Toro Adapter Kit, 2001 and Earlier 44" Snowthrowers to 2002 and Later GT Classic Garden Tractors Installation guide

Category
Wall & ceiling mounts accessories
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI