Connecting the DS6878 2d Imager to your Android or Windows Device
To connect the DS6878 scan gun to your Android Bluetooth device, please perform these
steps in this order.
1) If you have ever pair the gun to the device, go into the Bluetooth settings on your device and
select “forget this device” or “unpair”.
2) Turn your Bluetooth off.
3) Scan this code to reset to factory settings
4) Scan this code to enable BT pairing mode
5) Scan this code to enable a variable pin code when pairing (most Android devices require this)
6) Turn Bluetooth on your tablet, computer or phone to “on”. Select the DS6878 device
7) You will be issued a Pin CODE. Scan the Codes that represent the numbers of the PIN code and
“End of Message” if required.
8) Your Scan Gun should now connect to your device.
9) Scan the following codes (left to right) to add an Enter Key to the end of each string it decodes
10) Finally, it is strongly suggested you scan the following code to balance the output speed of the
scan gun to the input read speed of your device. Typically, this is 20Msec but varies based on
the specific device and browser you are using.
OPTIONAL based on your browser and specific mobile device
If for some reason the 20 msec is too slow you can try no delay.
If for some reason 20msec is too fast (if you get partial reads)
you can slow down to 40 msec.
/