Poly Planar ME-50 User manual

ME-50
Poly Planar
Brand
Poly Planar
Model
ME-50
Category
Soundbar speakers
Type
User manual

This manual is also suitable for

1352 Charwood Road • Suite D • Hanover, MD 21076 • Tel (410) 761-4000 • Fax (410) 761-6274 www.polyplanar.com
MP3-KIT-A
ME-50 Amp Settings
The ME-50 Amp is set at the factory at 70% of Max Volume.
In order to get Maximum Volume, adjust the Gain control fully
clockwise or to the desired level.
If the supplied Volume knob is used the MP3 player must be
set to full volume.
The Input Level should be set to “Line Level”
Adjust Player volume to full
Introduction:
The MP3-Kit is a simple system, designed to be used with MP3 audio storage devices (Ipod®, Mp3, etc).
System Overview:
The MP3KITA consists of 2 MA4055 speakers, ME-50 50 Watt amp with volume control and an IC3.5PM Adapter kit.
Installation considerations:
Read and follow the installation instructions provided with each system component.
Disconnect Battery power before installing this system.
Be sure there is clearance before cutting or drilling any holes.
Mount the ME-50 amp on a vertical surface if possible. Use the 4 mounting tabs and screws provided.
Use a 7/8” (22mm) drill bit or Paddle bit to drill the mounting hole for the Volume control knob. The volume
control knob is fitted with double stick gasket. Peel away the cover tape and press onto the dash. Plug the
Volume control into the ME50 amp. 3.5 Phono connector.
Use a ¾” (19mm) paddle type bit or drill bit to drill the mounting hole for the 3.5PM Adapter. Connect the
ends to the ME-50 “RCA Type” Phono Plugs.
Use the instructional material and templates supplied, to install the speakers. Be sure to use the correct
polarity on the speaker connections. These are clearly listed on the instruction supplied with the speakers.
Connect Blue wire from Amp to ignition switch, panel switch or other switched 12 volt source.
Note: Where switched 12v power is not available, connect both the Red and Blue wires of the ME50 together to
the 12v + source.
Playing:
With the Amp on and connected to the Headphone jack of the MP3Player, Switch on the Player and set the
volume of the player to max volume. The control of the amp volume is handled by the Waterproof Volume
control knob supplied with the Amp
Use the Player controls to select Playlists or individual track.
ME-50
12v - Negative
12v+ Positive
12v + Positive (Switched)
  • Page 1 1

Poly Planar ME-50 User manual

ME-50
Poly Planar
Brand
Poly Planar
Model
ME-50
Category
Soundbar speakers
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents