Philips HP4696/49 User manual

Page is loading ...

6

Introduction

Congratulations on your purchase and welcome to Philips! To fully benet

from the support that Philips offers, register your product at www.philips.

com/welcome.

With the new Salon Multistylist, you can create a unique look for every

occasion. It offers unlimited creativity and versatility in hairstyling.

General description (Fig. 1)

A Handle

B Power-on light

C Locking ring

D Slide-on brush

E Slide-on spiral

F Straightening plates (with curved and at sides)

G Small curling attachment

H Large curling attachment

I Paddle brush

J Straightening attachment

K Ready dot

L Lever

M Storage pouch

N Hair clips

Important

Read this user manual carefully before you use the appliance and save it

for future reference.

Danger

Keep the appliance away from water. Do not use it near or over

water contained in baths, washbasins, sinks etc. When you use the

appliance in a bathroom, unplug it after use.

Warning

Check if the voltage indicated on the appliance corresponds to the

local mains voltage before you connect the appliance.

-

ENGLISH

Check the condition of the mains cord regularly. Do not use the

appliance if the plug, the mains cord or the appliance itself is damaged.

If the mains cord is damaged, you must have it replaced by Philips, a

service centre authorised by Philips or similarly qualied persons in

order to avoid a hazard.

This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person

responsible for their safety.

Children should be supervised to ensure that they do not play with

the appliance.

Keep the appliance away from non-heat-resistant surfaces and never

cover the appliance with anything (e.g. a towel or clothing) when it is

hot.

Keep the appliance away from ammable items.

Never leave the appliance unattended when it is plugged in.

Always unplug the appliance after use.

Always return the appliance to a service centre authorised by Philips

for examination or repair. Repair by unqualied people could cause

an extremely hazardous situation for the user.

Caution

For additional protection, we advise you to install a residual current

device (RCD) in the electrical circuit that supplies the bathroom. This

RCD must have a rated residual operating current not higher than

30mA. Ask your installer for advice.

Keep the attachments clean and free of dust, dirt and styling products

such as mousse, spray and gel. Never use the appliance in

combination with styling products.

The attachments and the plastic parts near the attachments reach a

high temperature quickly. Prevent the hot surfaces of the appliance

from coming into contact with your skin.

The attachments have a ceramic coating. This coating slowly wears

away over time. This does not affect the performance of the

appliance.

-

ENGLISH 7

Do not leave attachments in your hair for more than a few seconds

at a time, to prevent damage to your hair.

Only use the appliance on dry hair.

Do not use the appliance on articial hair.

Do not use the appliance for any other purpose than described in

this manual.

Wait until the appliance has cooled down before you store it.

Do not wind the mains cord round the appliance.



This Philips appliance complies with all standards regarding

electromagnetic elds (EMF). If handled properly and according to the

instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Preparing for use

Connecting/disconnecting attachments

This procedure applies to all attachments.

1 Slide the attachment onto the handle. Make sure that the support

points downwards (Fig. 2).

2 Turn the locking ring on the handle to the right until the bold

arrow on the locking ring is in line with the arrow on the

handle (Fig. 3).

The attachment is now securely xed to the handle.

3 To disconnect attachments, turn the locking ring to the left and pull

the attachment off the handle.

Unplug the appliance when you remove an attachment after or during

styling. Do not touch the metal and ceramic parts of the attachment, as

they are hot.

Using the appliance

With the Salon Multistylist you can create tight curls, large curls, waves,

ringlets, icks and a sleek look.

-

ENGLISH8

1 Comb or brush your hair so that it is disentangled and smooth.

2 Connect an attachment to the handle (see chapter ‘Preparing for

use’). Make sure that the support points downwards.

3 Place the appliance on the support of the attachment.

4 Put the mains plug in the wall socket.

The power-on light goes on and the appliance heats up (Fig. 4).

The appliance is ready for use when the ready dot on the

attachment changes colour (Fig. 5).

5 Styleyourhair.Seethesectionsbelowforspecicinstructionsfor

each attachment.

Note: When you use one of the curling attachments or the slide-on brush,

always make sure that you wind the end of the lock in the required direction.

6 Leave the styler in your hair for a few seconds.

How long you have to keep the styler in your hair depends on the

thickness of your hair.

Do not leave the styler in your hair longer than 10 seconds.

Large or tight curls

1 Connect the large or small curling attachment to the handle.

2 Take a lock of hair, press the lever to open the clip and place the

lock between the barrel and the clip (Fig. 6).

3 Release the lever and slide the barrel to the end of the lock. Then

wind the lock round the barrel.

Note: Make sure that you wind the end of the lock in the required direction.

4 Open the clip after 5 to 10 seconds and remove the barrel from

the hair.

5 Letthecurlscooldownbeforeyoucomb,brushornger-comb

thehairintoitsnalstyle.

Tip: You can comb the curls with your ngers to add volume.

,

ENGLISH 9

Waves

1 Connect the small curling attachment to the handle. Slide the slide-

on brush onto the curling attachment.

2 Take a lock of hair and wind it round the slide-on brush (Fig. 7).

Prevent the slide-on brush from getting tangled in the hair in the

following way:

Do not put too much hair in one lock.

Do not wind a lock of hair more than twice round the slide-on brush.

When you unwind a lock of hair, make sure that you hold the slide-on

brush away from the underlying hair.

3 Remove the slide-on brush from your hair after 5 to 10 seconds.

4 Letthewavescooldownbeforeyoucomb,brushornger-comb

thehairintoitsnalstyle.

Ringlets

1 Connect the large curling attachment to the handle. Slide the slide-

on spiral onto the curling attachment.

2 Take a lock of hair, press the lever to open the clip and place the

lock between the barrel and the clip (Fig. 8).

3 Release the lever and slide the barrel to the end of the lock. Then

windthelockroundthebarrelfollowingthespiralprole.

Note: Make sure that you wind the end of the lock in the required direction.

4 Open the clip after 5 to 10 seconds and remove the barrel from

the hair.

5 Lettheringletscooldownbeforeyoucomb,brushornger-comb

thehairintoitsnalstyle.

Flicks

1 Connect the straightening attachment to the handle.

2 Slide the straightening plates into the attachment with the curved

sides pointing towards each other (Fig. 9).

-

ENGLISH10

3 Take a lock of hair (max. 5 to 6cm wide). Press the lever to open

the straightening attachment and place the lock between the

plates (Fig. 10).

Decide if you want to create inward or outward icks. Hold the appliance

in such a way that the curved sides of the plates create the desired type

of ick.

4 Slide the styler gently down the length of the hair in a few seconds.

When the plates are 3-5cm above the end of the lock, slightly twist

the appliance inwards or outwards to create the desired type of

ick.

Sleek look

1 Press the lever to open the straightening attachment.

2 Remove the straightening plates one by one. Grab the cool tip and

pull each plate out of the straightening attachment (Fig. 11).

3 Turn the plates round and slide them back into the attachment with

theatsidespointingtowardseachother(Fig.12).

You can now use the straightening attachment to create sleek hair

without icks.

Make sure that the edges of the plates are inserted properly into the

grooves.

4 Take a lock of hair (max. 5 to 6cm wide). Press the lever to open

the straightening attachment and place the lock between the plates.

5 Slide the styler gently down the length of the hair in a few seconds.

6 Let the sleek hair cool down before you comb or brush it.

Cleaning

Never immerse the appliance in water or any other liquid, nor rinse it

under the tap.

1 Unplug the appliance.

ENGLISH 11

2 Place the styler on the support of the attachment in a safe place

and let it cool down.

3 Clean the appliance and the attachments with a small brush or a

dry cloth.

Storage

1

Unplug the appliance.

2 Place the styler on the support of the attachment in a safe place

and let it cool down.

3 Store the appliance in a safe and dry place.

Do not wind the mains cord round the appliance.

Environment

Do not throw away the appliance with the normal household waste

at the end of its life, but hand it in at an ofcial collection point for

recycling. By doing this, you help to preserve the

environment (Fig. 13).

Guarantee & service

If you need information or if you have a problem, please visit the Philips

website at www.philips.com or contact the Philips Customer Care

Centre in your country (you nd its phone number in the worldwide

guarantee leaet). If there is no Customer Care Centre in your country,

go to your local Philips dealer or contact the Service Department of

Philips Domestic Appliances and Personal Care BV.

Troubleshooting

This chapter summarises the most common problems you could

encounter with the appliance. If you are unable to solve the problem with

the information below, contact the Customer Care Centre in your

country.

-

ENGLISH12

Problem Solution

The appliance

does not work.

Perhaps there is a power failure or the socket is not

live. Check if the power supply works. If it does, plug

in another appliance to check whether the socket is

live.

Perhaps the appliance is not suitable for the mains

voltage to which it is connected. Make sure that the

voltage indicated on the appliance corresponds to

the local mains voltage.

Perhaps the mains cord of the appliance is damaged.

If the mains cord is damaged, you must have it

replaced by Philips, a service centre authorised by

Philips or similarly qualied persons in order to avoid

a hazard.

The styling

results are not

satisfactory.

Perhaps you did not let the appliance heat up long

enough. Let the appliance heat up until the ready

dot changes colour.

Perhaps you wound too much hair round the barrel

or put too much hair between the plates. When you

use the curling attachments or the slide-on brush, do

not make the locks too thick. The thinner the lock of

hair, the tighter the curl. When you use

the straightening attachment, make sure the locks are

no wider than 5 to 6cm for a good result.

Perhaps you did not leave the styling attachment in

your hair long enough. Keep the styler in your hair

for 5 to 10 seconds, depending on the thickness of

your hair.

ENGLISH 13

Page is loading ...

4222.002.7046.1www.philips.com

u

Philips HP4696/49, HP4696, HP4696/00, HP4696/01, HP4696/07, HP4696/09, HP4696/10, HP4696/29, HP4696/39, HP4696/87, SalonMultistylist User manual

Related papers

Other documents