7
BB.. SSttaarrttiinngg uupp
BB..22 UUnnppaacckkiinngg aanndd aasssseemmbblliinngg
CCoonnnneeccttiioonn ttoo ppoowweerr ssuuppppllyy::
- Check that the data on the data plate coincides with the local vol-
tage before connection calculator to power supply.
- Connect calculator to power supply.
IInnsseerrttiinngg tthhee ppaappeerr rroollll ((AArrtt.. NNoo.. 0066..886600..11111155))::
- Fit the paper roll holder
- Roll out paper, leading edge to the top, into the guides
- Turn calculator on
- Paper is drawn into paper slot
- Feed paper as far as possible until it stops at the rear opening
- Use to insert the paper further
TTuurrnniinngg OONN // OOFFFF::
When turned on, the calculator is ready to operate.
At least 3 seconds should elapse between turning on and off
again.
BB..33 GGeenneerraall iinnffoorrmmaattiioonn
AAccccuummuullaattoorr::
Products, quotients and individual value can be totaled and stored
in the accumulator. Multiplication and division are ignored.
EEnnttrriieess::
Value and sub-totals are transmitted directly to the accumulator via
the addition and subtraction keys.
CCoonnssttaannttss::
The multiplicand, divisor, basic value or percentage, including the
subsequent function, are automatically retained as constants.
RReeppeeaatt vvaalluuee::
Using the basic calculation modes, a value can be repeatedly used
as often as required.
PPaappeerr rroollll pprriinnttoouutt::
The decimal place is printed as a comma,
Examples:
EEnntteerriinngg vvaalluueess aanndd ccaallccuullaattiioonn mmeetthhooddss::
- Addition / Subtraction (a+b+c+)
Result via
- Multiplikation / Division (axbVc=)
Result via
TTrriiaadd ggrroouupp ssyymmbboollss ((ccoommmmaass)) sshhoowwnn iinn ddiissppllaayy::
Values to the left of the decimal point are divided by triad symbols.
Example:
CCaappaacciittyy oovveerrffllooww::
When results exceed 14 full digits “………………..” is printed out,
an “E” appears in the display and the keyboard is blocked for entry.
To release the keyboard;
press: or or .
MMeemmoorryy bblloocckk::
The memory will not accept a value which would exceed the me-
mory capacity. The memory contents remain unaltered.
IItteemm ccoouunntteerr ((SSwwiittcchh ppoossiittiioonn))::
When activated a 3 digit item counter is provided for the accumula-
tor and for the memory.
By pressing and or and the number of additions
and subtractions are counted.
The number of item is printed on requesting sub-totals or final to-
tal. Example:008 = 8 items.
Pressing the final total key clears the counter.
SSttoorreedd rraatteess && mmeemmoorryy ccoonntteennttss rreettaaiinneedd::
The memory contents and stored rates of conversion, tax and %
will be retained even if the calculator is turned off.
The 11 pre-programmed fixed Euro rates are available for different
countries (refer “Currency code table” page 31.) and are originally
installed in the calculator. It is not possible to change such
preprogrammed rate at any time.
CCuurrrreennccyy ccoonnvveerrssiioonn::
- The conversion rate consists of 6 significant figures with the deci-
mal points.
- Additionally, 5-currency conversion rates can be programmable
and stored.
- To convert between ‘1st currency‘ and ‘2nd currency‘ through
conversion rate, the 1st currency and the 2nd currency will be se-
lect among ‘Euro’, ‘originally installed 11-currency’ and ‘stored 5-
currency’.
- Conversion rate is printed out with the currency symbol.
- Euro currency can be printed out with the following symbol mark:
5
- Refer to “Currency code table” page 31.
TTaaxx RRaattee::
- Tax rate consists of 6 significant figures with decimal point.
- Tax rate is printed out with the symbol of RT.
AAuuttoommaattiicc %%++ ccaallccuullaattiioonn ((ppeerrcceenntt aadddd--oonn))::
- Automatic %+ calculation can proceed with user stored % rate or
entry % rate.
- The user stored % rate consists of 6 significant figures with deci-
mal point.
- Stored % rate is printed out with the symbol of R%.
BB..44 KKeeyybbooaarrdd ssuummmmaarryy
The keyboard has an input buffer which enables all entries, regard-
less of speed of input, to be proceeded in order of input.
Total clearance
- The complete calculation process is cleared. Memory con-
tents are retained.
- The stored rates are retained even after depressing this
key.
Recall item counter
- Press once:
Recall number of added items
- Press twice, after recall of final sum or sub-total:
Recall arithmetic mode average of item addition and sub-
traction.
Non-add key
- Date or number printout.
Correction key
- Clear entered value.
Algebraic sign change key
- To specify a positive or negative value.
Digit keys
- The values entered appear in the display.
Decimal point key
Subtraction key
Addition key
Sub-total key
- Recall accumulator / item counter contents
Final total key
- Recall and clear accumulator / item counter contents
Percent key
Together with :
- Recall percent value.
Together with and or :
- Recall the value plus or minus the percent value.
Division key
V
_
+x
x
%
X
+
–
.
+/-
CE
#
n
C
008 600.00_
M–M+–+
R
CCE
123.456.789.012,34
=
X
123 456 789 012,34+
q
9
–
0