Cumberland MF-36ED Damper Magnet Retro Owner's manual

  • Hello! I have reviewed the instructions for the Hired-Hand Magnet Retro Assembly MF-36ED 6450-9095. This document provides detailed steps for installing the magnet bracket assembly, including how to measure and place the components, and it emphasizes safety precautions. I'm ready to answer your questions about the assembly process or any other details you may need.
  • What tools are required for assembly?
    What should I do if parts are missing?
    What is the first step in the assembly process?
    Where should I measure on the horizontal bar?
HIRED-HAND MFG., INC. 1759o Rd 68 Bremen, Alabama, 35033, PO Box 110 Phone 256-287-3500,
Fax 265-287-2000, Instruction Sheet Number 4802-6500 Rev. 3-11
DAMPER MAGNET RETRO ASSEMBLY
12 1/2
12 1/2
Correct Ma
g
net Location
Assembly Instructions
1. Turn off all power to the fan.
2. Remove the inlet screen from the back (intake) side of the fan.
3. Check current magnet placement on ring (See drawing below).
4. If magnet placement is incorrect, remove old magnets with pliers.
5. Measure along the backside of the Horizontal Bar from outside edge of Ring 12-1/2 inches on each
side and mark location on the backside of the Horizontal Bar.
6. Line up the hole in the top section of the bracket with the mark and screw in 1004-7076 screw.
7. Screw second 1004-7076 screw into hole in bottom section of bracket.
8. Repeat on opposite side of the Damper Ring.
Copyright © 2008 by Group
Printed in the USA
/KIT MF-36ED MAGNET RETRO FIT (6450-9095)
Part Number Qty Description
6403-2601 2 /MF-36ED Magnet/Brkt Assy
1004-7076 4 Scrw Tek #8x1/2 RD Phil W Hd Z
IMPORTANT!
Locate packing slip and make sure that all listed parts are
enclosed. If not, call your Hired-Hand distributor
immediately.
Tools Required:
Cordless Drill
Pliers
Phillips Head Driver / Screwdriver
Measuring Tape
CAUTION!
Read all instructions before assembling Magnet / Bracket
Retro Assembly!
Back of Damper Ring
/