Glacier Bay RP90153 Installation guide

Installing the Cartridge/Installing the Cartridge

□Remove the set screw (2) with a Hex wrench (Hex: 2.5 mm, 1).

Model# / Modelo núm. RP90153

□Remove the handles (3) , the ﬂanges (4) and the Bonnet nut (5) by unscrewing it from the valve body (7).

□Replace the Cartridge (6) .

□Reinstall the handles (3) , the ﬂanges (4) and the Bonnet nut (5) back onto valve body (7) .

□Remove the set screw (2) with a Hex wrench (Hex: 2.5 mm, 1).

□Remove the handles (3) , the ﬂanges (4) and the Bonnet nut (5) by unscrewing it from the valve body (7).

□Replace the Cartridge (6) .

□Reinstall the handles (3) , the ﬂanges (4) and the Bonnet nut (5) back onto valve body (7) .

CAUTION: Always shut off the water supply before removing an existing faucet or replacing any part of a faucet. Open the faucet handle

to relieve water pressure and ensure that the water is completely shut off.

PRECAUCIÓN: Cierra siempre el suministro de agua antes de retirar un grifo existente o reemplazar alguna parte del mismo. Abre la

llave del grifo para liberar la presión de agua y asegúrate de que el suministro de agua esté completamente cerrado.