High Power Bagless
Upright Vacuum
Cleaning Guide
®
MD
®
MD
SURFACEELITE
™/MC
STEP 2: CLEANING PRE-FILTER
STEP 1: EMPTYING THE DUST CUP
Make sure the vacuum is turned off. Slide the
dust cup release button to remove it from the
main body.
Press down on the dust release button to open
dust cup lid and allow contents to drop into
waste receptacle.
Grasp pre-filter and rotate counterclockwise
to remove. Clean pre-filter by gently tapping
over a trash container. Tap on several sides to
ensure best cleaning.
Rinse the pre-filter with cold water if needed.
DO NOT use any detergent or soap,
and avoid washing it in the dishwasher.
Make sure the pre-filter is completely dry before
installing it. To replace the pre-filter in the dust cup,
hold it and turn it clockwise until it locks into place.
Wash Foam Filter. Remove the foam filter.Remove the foam filter.
Allow Filters to fully dry then replace foam and
felt filters into the vacuum cleaner.
Wash Felt Filter. Reinstall the dust cup on to the vacuum.
Remove HEPA exhaust cover shown in the first
image by pressing the tab a the bottom of the
cover explosing the HEPA filter shown, remove by
pulling out.
Wash with cold water only, DO NOT use
detergent or soap. Allow parts to dry 24 hours
before putting back into vacuum cleaner.
Replace the HEPA media exhaust filter into
the vacuum cleaner and cover.
Replace HEPA Filter every 3 months
DO NOT install damp and DO NOT operate without exhaust filter installed.
a b
STEP 3: CLEANING FOAM AND FELT FILTERS
STEP 4: CLEANING HEPA MEDIA EXHAUST FILTER
It is recommended to clean the foam and felt filters with cold water every three months.
-
1
-
2
NOMA SurfaceElite+ High Power Bagless Carry-off Corded Owner's manual
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Vax 24 Owner's manual
-
Shark UV440 User manual
-
Eureka NEU526 User manual
-
-
-
-
-
-
-