NOMA SurfaceElite High Power Bagless Corded , SurfaceElite+ High Power Bagless Carry-off Corded Owner's manual

Hello! I'm a chat assistant ready to help you with your NOMA SURFACE ELITE Upright Vacuum. I've reviewed the user guide and can assist with questions about emptying the dust cup, cleaning the various filters, and general maintenance. Feel free to ask me anything about the provided document.
How do I remove the dust cup?

How do I clean the pre-filter?

How often should I clean the foam and felt filters?

How often should I replace HEPA Filter?

High Power Bagless

Upright Vacuum

Cleaning Guide

SURFACEELITE

™/MC

STEP 2: CLEANING PRE-FILTER

STEP 1: EMPTYING THE DUST CUP

Make sure the vacuum is turned off. Slide the

dust cup release button to remove it from the

main body.

Press down on the dust release button to open

dust cup lid and allow contents to drop into

waste receptacle.

Grasp pre-filter and rotate counterclockwise

to remove. Clean pre-filter by gently tapping

over a trash container. Tap on several sides to

ensure best cleaning.

Rinse the pre-filter with cold water if needed.

DO NOT use any detergent or soap,

and avoid washing it in the dishwasher.

Make sure the pre-filter is completely dry before

installing it. To replace the pre-filter in the dust cup,

hold it and turn it clockwise until it locks into place.

Wash Foam Filter. Remove the foam filter.Remove the foam filter.

Allow Filters to fully dry then replace foam and

felt filters into the vacuum cleaner.

Wash Felt Filter. Reinstall the dust cup on to the vacuum.

Remove HEPA exhaust cover shown in the first

image by pressing the tab a the bottom of the

cover explosing the HEPA filter shown, remove by

pulling out.

Wash with cold water only, DO NOT use

detergent or soap. Allow parts to dry 24 hours

before putting back into vacuum cleaner.

Replace the HEPA media exhaust filter into

the vacuum cleaner and cover.

Replace HEPA Filter every 3 months

DO NOT install damp and DO NOT operate without exhaust filter installed.

a b

STEP 3: CLEANING FOAM AND FELT FILTERS

STEP 4: CLEANING HEPA MEDIA EXHAUST FILTER

It is recommended to clean the foam and felt filters with cold water every three months.