#3BErgo Handle with
ON/OFF Switch,
& Air Flow Control
#4A Push Button Locking
Wands With Cord Channel
#3 Electric
Power Hose
Suction End Cap
# 4 Electric
Power Nozzle
#5 & #6 Power Nozzle
Cord
#3A Electric Hose
Power Supply Cord
#2 Two Speed HI/LOW
ON/OFF Switch.
(Blower End)
#7 ON/OFF Switch For
Revolving Brush
INTRODUCING THE NEW
“METROPOLITAN PROFESSIONAL” LINE
In the major appliance industry, stainless steel has
quickly become the trademark of quality, professionally
engineered, consumer products that look and perform as if
they were being utilized in a commercial environment.
This was our goal in designing the “Metropolitan
Professionals” line of Stainless Steel/Chrome Floor Care
Products. Inside the sleek exterior, you will find the
quality, performing components that has built the
Metropolitan Vacuum Cleaner Company, Inc. reputation.
Up to 4.0 Peak Horsepower and Six Layer HEPA Filtration
provide you with unsurpassed performance.
HOME CLEANING SYSTEM
Model ADM-4PNHSF
INSTRUCTION MANUAL
1. Insert male plug from vacuum into electrical outlet.
2. Start appliance by pushing the toggle switch from “Off”
position to “On”. Note: On the ADM-4PNHSF model push
toggle switch from “Off” position to “Low” or “High” speed.
3. Electric Hose: Connect the electric hose by inserting the short,
straight coupling into the suction end of the power unit. Depress
the buttons on coupling to insert and remove hose. (#3A) Plug
in power supply cord from electric hose into power nozzle
receptacle on power unit. “On/Off” switch on ergonomically
correct pistol grip allows you to go from carpet to bare floors
with a flick of a switch. (See figure #3B)
4. “Electric” Power Nozzle: Assemble electric power nozzle by
fitting chrome push button extension wands (#4A) into power
nozzle neck.
5. Snap power nozzle power cord into channel on push button
extension wands.
6. Plug power nozzle power cord into receptacle on hose handle.
7. Depressing “pedal” on electric power nozzle, disengages the
revolving brush, while the headlight remains on allowing you to
go from carpet to bare floors. (See figure #7)
8. Combo Carpet/ Floor Tool: Attach to the steel chrome
extension wands to clean carpeting. Depress pedal for bare
floors or carpeting. The swivel action permits proper contact
with all surfaces. (Not included in all models)
9. Floor & Wall Brush: Used with extension wands for cleaning
walls, hardwood, tile , cement or linoleum surfaces
(not included in all models).
10. Crevice Tool: Cleans those hard-to-reach, tight places such as
radiators, pianos, baseboards and around the cushions of
upholstered furniture.
11. Dusting Brush: Long soft bristles gently loosen dust on
furniture, lamp shades, blinds, picture frames, moldings, etc.
12. Upholstery Nozzle: Cleans upholstered furniture, draperies,
mattresses, pillows, clothing, furs, automobile interiors