Mercedes-Benz E320 Owner's manual
- Category
- Cars
- Type
- Owner's manual
This manual is also suitable for
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HEX BOLT7/16-14 x 1 1/281
WASHER7/16 WASHER82
HEX FLANGE NUT7/16-1483
.188" DRIVER SIDE BRACKETCM-11806-DSB1
4
.188" PASSENGER SIDE BRACKETCM-11806-PSB
15
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,500 200
20
20
87-96 MERCEDES BENZ 300TE,TD & E320
11/19/2012
11806
40
257216
3
1
2
-DRILLING REQUIRED
-REMOVE PANELS
FRAME RAIL
(BOTH SIDES)
DRILL HOLE (ALL)
1. Open rear door and remove the floor and wall panels for access to center compartment and side wells.
Remove spare tire from left side well. Side wells are separated from center compartment by vertical metal
panels, remove the two plugs in each panel. Left and right brackets provided with hitch must bolt at these
panel holes inside each side well. Any body filler material blocking opening of side wells where bracket
installs to must be cleaned away so channel rests flat on bodywork. Fasten channels to car as shown.
2. The hitch receiver assembly is placed up under car just forward of rear bumper and behind car's exhaust on
flat area just large enough for receiver. Center hitch on car and drill mounting holes. Install fasteners as
shown.
3. Torque all 7/16" hardware to 70 lb.-ft.
4
5
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501
-
1
Mercedes-Benz E320 Owner's manual
- Category
- Cars
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Curt Manufacturing 11543 Owner's manual
-
CURT 110683 Installation guide
-
-
-
-
-
-
-
-