Baxton Studio RH367C-Grey/Walnut-5PC Dining Set, RH367C-Sand/Walnut-5PC Dining Set Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the 367C chair. This document provides a detailed guide on how to assemble your new chair, with step-by-step procedures, a parts list, and cautionary tips to help you with the assembly process. I'm ready to answer any questions you might have about assembling this product.
  • What should I do before starting the assembly?
    Should I fully tighten all screws immediately?
    What should I avoid when tightening the screws?
ASSEMBLY INSTRUCTION MODEL : 367C
Read this instruction carefully. Remove all wrapping material, staples and straps from the carton.
See hardware and furniture part list
For guidance. Be sure you have all wooden furniture parts on a clean and flat soft surface, such as
a carpet or rug, to prevent from being scratched.Follow the figure to start assembling.
CAUTION :
1. Do not FULLY - TIGHTEN the nut or screw untill all is ready to assemble.
2. Do not OVER - TIGHTEN the nut or screw to avoid causing damages to the thread.
3. Keep all hardware part out reach of children.
COMPELETE
ASSEMBLE
STEP 1.1 STEP 4
CUSHION
SEAT
Firstly, stick E to C for both left and
right side.
E
C
STEP 1.2
Then, attached STEP 1.1 to B according
to the hole and lock using hardware
number 1,3,4 and 5.
5
1
4
3
C
B
STEP 2
Proceed with combine the whole part
from STEP1.2 to A . Tighten the part of
C and A using hardware number 1,4 and
5 .
C
A
4
1
5
A
C
C
D
STEP 3
Stick D to the whole assemble part and
fully-tighten it with hardware number 2 .
PART LISTNO QTY
ABACK REST
BFRONT LEG
CSIDE RAIL 2 PCS
DCUSHION SEAT 1 PC
1 PC
1 PC
DESCRIPTIONNO QTY
1JCBC SCREW M6 X 50MM 6 PCS
2
3
4SPRING WASHER
M4 ALLEN KEY 1 PC
CSK SCREW M4 x 30MM 3 PCS
WOOD DOWEL Ø8 x 30MM 4 PCS
55
E1 PCCENTER SUPPORT
6 PCS
2 X 3PCS
A TABLE TOP
B TABLE LEG 4 PCS
1 PC 1
2
3
4
JCBC SCREW M6 x 70MM
FLAT WASHER 1/4"
SPRING WASHER 1/4"
M4 ALLEN KEY
8 PCS
1 PC
8 PCS
8 PCS
Read this instruction carefully. Remove all wrapping material, staples and straps from the carton. See hardware and
furniture part list
For guidance. Be sure you have all wooden furniture parts on a clean and flat soft surface, such as a carpet or rug, to
prevent from being scratched.Follow the figure to start assembling.
CAUTION :
1. Do not FULLY - TIGHTEN the nut or screw untill all is ready to assemble.
2. Do not OVER - TIGHTEN the nut or screw to avoid causing damages to the thread.
3. Keep all hardware part out reach of children.
MODEL : 7206T
ASSEMBLY INSTRUCTION
PART LIST
NO QTY DESRIPTION
NO QTY
COMPELETE ASSEMBLE
/