Supermicro X9SRW-F Quick Reference Manual

Brand: Supermicro

Model: X9SRW-F

Type: Quick Reference Manual

UPERMICR

CONTACT INFORMATION

MNL-1319-QRG REV. 1.00

• www.supermicro.com (Email: [email protected])

• Manuals: http://www.supermicro.com/support/manuals

• Drivers & Utilities: ftp://ftp.supermicro.com

• Safety: http://www.supermicro.com/about/policies/safety_information.cfm

consent. All Trademarks are property of their respective entities. All information provided is deemed accurate at the time of printing; however, it is not guaranteed.

PACKAGE CONTENTS

(Applies to individual-pack only)

X9SRW-F

QUICK REFERENCE GUIDE REV. 1.00

• One (1) Supermicro Motherboard

• Eight (8) SATA Cables

• One (1) I/O Shield

• One (1) Quick Reference Guide

JLAN1JLAN2

JUIDB1

JSTBY1

JIPMB1

JI2C1

Socket R

LGA 2011

CPU

DESIGNED IN USA

SXB2

SXB1B

JD1

JPWR1

T-SGPIO4

T-SGPIO3

T-SGPIO1

T-SGPIO2

JF1

JUSBKM

SXB1A

SAS2

SAS1

SAS3

SAS4

J17

H-HS2_2

SP1

JBT1

BD1

LED2

LE2

LE1

BT1

JOH1

JL1

R136

JVGA1

JTPM1

J26

J23

JCOM1

FAN5

FAN4

FAN3

FAN2

FAN1

JWF1

C241

JWP1

JI2C3

JI2C2

JPG1

JPB1

JP3

JPME1

JWD

JPL1

SXB1B: LEFT_WIO_MIDDLE

SXB2: RIGHT_WIO

SXB1A: LEFT_WIO_UP

WRITE PROTECT

JWP1:

USB

1-2:RST

2-3:NIMI

JWD:

JI2C2/JI2C3

1-2:Enable

2-3:Disable

JPMB

OFF:NORMAL

ON:ME RECOVERY

JPME1:

VGA

UID

JTPM1: TPM/PORT80

DIMM4A

DIMM4B

DIMM3B

DIMM3A

KB/MOUSEUSB/2/3

JTPM1:TPM/PORT80

JSTBY1:STAND BY POWER FOR DOM

2-3:NMI

1-2:RST(DEFAULT)

JWD:WATCH DOG TIMER

JD1:

4-7:SPEAKER

1-2:PWR_LED

IPMI LAN

USB/0/1

1-2:ENABLE

2-3:DISABLE

JPL2:LAN2

JPL1:LAN1

2-3:DISABLE

1-2:ENABLE

JPB1: BMC

COM1

JBT1:CMOS CLEAR

LAN2

JL1

LAN1

DIMM2B

DIMM2A

JI2C1

2-3:Disable

1-2:Enable

JOH1:OVER HEAT LED

CPU

OFF:Disable

ON:Enable

2-3:DISABLE

1-2:ENABLE

:CHASSIS INTRUSION

I-SATA3

I-SATA4

I-SATA2

I-SATA1

I-SATA0

I-SATA5

DIMM1B

DIMM1A

JPG1: VGA

J29

J30

CPU1

CLOSE 1st

OPEN 1st

Memory Population Guidelines

When installing memory modules, populate the DIMM slots in the following or-

der: DIMMA1, DIMMB1, DIMMC1, DIMMD1 then DIMMA2, DIMMB2, DIMMC2,

DIMMD2. Populate the blue-colored slots ﬁ rst.

• Always use DDR3 DIMM modules of the same size, type and speed.

• Mixed DIMM speeds can be installed. However, all DIMMs will run at the speed

of the slowest DIMM.

• The motherboard will support odd-numbered modules installed (1 ,3 ,5 ,or 7

modules). However, for best memory performance, install DIMM modules in

pairs.

Recommended Population (Balanced)

DIMMA1 DIMMB1 DIMMC1 DIMMD1 DIMMA2 DIMMB2 DIMMC2 DIMMD2 Total

2GB 2GB 4GB

2GB 2GB 2GB 2GB 8GB

2GB 2GB 2GB 2GB 2GB 2GB 12GB

2GB 2GB 2GB 2GB 2GB 2GB 2GB 2GB 16GB

Jumpers, Connectors and LED Indicators

Back Panel I/O Connectors

Memory Support

Motherboard Layout and Features

CPU Installation

Note: Graphics shown in this quick reference guide are for illustration only. Your components may or may not look exactly the same as drawings shown in this guide.

Note: Refer to Chapter 1 of the User Manual for detailed information on jumpers, connectors,

and LED indicators.

Note: Refer to Chapter 2 of the User Manual for detailed information on memory support and CPU/

motherboard installation instructions.

= mounting hole

Heatsink Installation

Front Panel Control (JF1)

Jumpers

Connectors

LED Indicators

The X9SRW Motherboard supports up to 256GB of 1600/1333/1066/800 MHz

ECC/Non-ECC DDR3 DIMMs in eight (8) memory slots (UDIMM/RDIMM).

Note: For memory optimization, use only DIMM modules that have been validated by Supermicro.

For the latest memory updates, please refer to our website a at http://www.supermicro.com/

products/motherboard.

DIMM Memory Installation

A. COM 1 G. LAN1

B. IPMI Port H. LAN2

C. USB 2.0 Port 1 I. VGA Port

D. USB 2.0 Port 0

E. USB 2.0 Port 3

F. USB 2.0 Port 2

G H

10 UID Unit ID Switch Off (Disabled)

11, 12 JI2C3/JI2C2 SMB to PCI Slots On (Enabled)

16 JPG1 Onboard VGA Enable Pins 1-2 (On)

45 JWP1 BIOS Write Protect Pins 1-2 (Normal)

46 JPL1 LAN1 Enable Pins 1-2 (Enabled)

50 JWD Watch Dog Timer Reset Pins 1-2 (Reset)

52 JP3 BIOS Recover Pins 2-3 (Open)

54 J30 VRM SMB Data (to BMC or PCH) Pins 1-2 (BMC, Normal)

55 J29 VRM SMB Clock (to BMC or PCH) Pins 1-2 (BMC, Normal)

56 JPB1 IPMI/BMC Enable Pins 1-2 (Enabled)

57 JPME1 Intel ME Mode Select Pins 1-2 (Normal)

58 JBT1 CMOS Clear Short contact pads to clear CMOS

1 JCOM1 Back panel Serial Port Connector

2, 4 USB0/1, USB2/3 Back panel USB 2.0 ports

3 IPMI Back panel IPMI LAN Port

5, 6 JLAN1/JLAN2 Back panel LAN1 / LAN2 Ethernet Ports

7 JVGA1 Back panel VGA Port

14, 17 SXB1A, SXB1B Supemicro riser card slot (P/N RSC-R1UW-2E16)

15 SXB2 Supemicro riser card slot (P/N RSC-R1UW-E8R)

18, 19, 60, 61 I-SAS 0,1,3,2 (SATA 3.0) I-SATA 3.0 ports (supports up to 6Gb/s)

20, 21 I-SATA0, I-SATA1 (SATA 3.0) Internal SATA ports (up to 6Gb/s)

22, 23, 24, 25 I-SATA 2,3,4,5 (SATA 2.0) Internal SATA ports (up to 3Gb/s)

26 JSD1 SATA DOM (Disk On Module) Power Connector

27 JL1 Chassis Intrusion Header

28,29,31,32,33 FAN 5,4,3,2,1 Front Panel Control Header

30 JF1

34 JPW1 24-pin Main ATX Power Connector

35 JPW2 8-pin Secondary Power Connector

37 JD1 Pwr LED / Speaker Header (Pins 4~7:Ext Speaker)

38 JPI2C1 Power Supply SMBus I2C Header

39, 40, 41, 42 T-SGPIO1~4 Serial Link General Purpose I/O Headers

43 JTPM1 Trusted Platform Module (TPM) Header

44 JSTBY1 Legacy Wake On LAN Header

47, 48 USB4/5, 8/9 Internal USB 2.0 headers

49 JIPMB1 System Management Bus Header (IPMI Slot)

51 BT1 System Battery

53 JOH1 Overheat LED/Fan Fail

59 SP1 Internal Speaker / Buzzer

8 LE2 UID LED Blue/Steady UID Switch is On

9 BD1 IPMI Heartbeat Green/Blinking IPMI is enabled

13 LED2 Standby 3.3V Power Green/Steady Standby Power

36 LE1 Power LED Green/Steady System is On/Running

DIMMA1 (Blue Slot)

DIMMA2

DIMMB1 (Blue Slot)

DIMMB2

DIMMC1 (Blue Slot)

DIMMC2

DIMMD1 (Blue Slot)

DIMMD2

CPU

Note: The motherboard supports up to 256GB of total memory. Please consult the user's manual

for more populating options.

Power Button

OH/Fan Fail LED

NIC1 LED

Reset Button

HDD LED

Power LED

#3~4

#1~2

Vcc

UID LED

Ground

1920

Vcc

NIC2 LED

NMI

Ground

Align Socket Keys

OPEN 1st

Motherboard

Screw#1

Screw#2

20 21

22 23

24 25

DIMMD1

DIMMD2

DIMMC1

DIMMC2

DIMMB1

DIMMB2

DIMMA1

DIMMA2

Supermicro X9SRW-F Quick Reference Manual

Supermicro X9SRW-F Quick Reference Manual

Supermicro X9SRW-F Quick Reference Manual

Related papers