SPEEDI-GRILLE TB-PAB 10 Operating instructions

T-Bar Register Grille Installation

Steps:

1. Remove the ceiling tile where the grille will be installed.

2. Remove the adjacent ceiling tile for access to ducting.

3. Place T-Bar grille into suspended ceiling grid.

Note: Grilles can be secured at seismic support holes.

(Seismic anchor brackets not included).

4. Slide the flexible duct onto the grille collar.

5. Secure ducting with foil duct tape and large zip tie (not provided).

6. Finish by placing the adjacent tile back into place.

This manual is also suitable for