Item #_________________
Crimsco Inc. Correctional Meal Delivery Systems
Model IMC-1014 Series
Holding and Transport Cabinet
For 10” x 14” Trays
Standard Features
▼ 12 gauge Lockable transport latch
▼ Tamper proof fasteners throughout
▼ Top Mounted Forced Air Heating System
▼ Fully insulated
▼ Fully Welded Removable Tray Slides
▼ Lexan™ Covered Dial Thermometer
▼ Adjustable Thermostat Equipped with Security
Cover
▼ Flush recessed door pull
▼ Heavy duty 5” casters
▼ Magnetic door closure
▼ All stainless steel
▼ Fully welded
▼ Integral dual layer fully welded corner posts
▼ Super duty reinforced base
▼ 270 degree door swing
▼ Full perimeter bumper
▼ One year parts and labor warranty
▼ (3) Fully welded 12 gauge hinges
▼ Face mounted “sure seal gasket”
IMC-48-1014 Shown
IMC-1014 Series Meal Delivery
Cabinets
These rugged, built to last delivery carts are fully insulated
and are designed for secure, fast meal
delivery service.
These carts are not just some restaurant style cart with
security features attached. Our carts are
manufactured from the ground up specifically for the
correctional field.
Our reinforced fully welded base and integral
Dual layer fully welded corner post design insures the
elimination of any cabinet torque during transport.
Our top mounted forced air heating system is designed for
superior heat temping times as well as fantastic heat
retention. Our easy to use controls make using this cart
as easy as a push of a button
The bottom line is, your environment is tough! Our
standards are even tougher!
Options
▼ Upgrade to semi-pneumatic casters
▼ Ambient configuration
▼ No racking (stacked trays)
Crimsco a Division of ITW FEG
7737 N 81
st
Street Milwaukee, WI 53223 USA
414-702-8972 / 800-367-8413 / Fax 414-354-2821
Form # 41143 (9/09)
Item #_________________
Crimsco Inc. Correctional Meal Delivery Systems
Model IMC-1014 Series
Holding and Transport Cabinet
For 10” x 14” Trays
Crimsco a Division of ITW FEG
7737 N 81
st
Street Milwaukee, WI 53223 USA
414-702-8972 / 800-367-8413 / Fax 414-354-2821
Form # 41143 (9/09)
Model
Capacity
Width
Depth
Height
Weight
Electrical
NEMA
Casters
IMC-48-1014
48 trays
28”
34.5”
53”
400 lbs
120v
1000 watts
115v 8’
5-15P
5”
IMC-72-1014
72 trays
28”
34.5”
65”
475 lbs
120v
1000 watts
115v 8’
5-15P
5”
Construction: Heliarc welded, fully insulated, stainless steel
double pan construction. Support channels welded at base,
integral dual layer fully welded corner posts (all four corners).
Bumper: Continuous wrap around aluminum (dove-tail)
designed bumper complete with (secure fit) non-marking vinyl
insert.
Doors: Double pan design, fully insulated, 270 degree swing,
12 gauge hinges, recessed door pulls
Heating system: Top mounted forced air, with rear
mounted “tunnel” distribution system. Dial thermometer
equipped with lexan™ cover, adjustable thermostat equipped
with security cover, lighted on/off switch.
Casters: 5” super duty polyurethane casters mounted to 1/4 inch
mounting plates. (2) swivel with brakes (2) rigid.
Casters equipped with mounting plate shall be secured to
reinforced base channel with 3/8” carriage bolts.
Security Detail: All fasteners shall be tamper proof, hinges and
transport latches are 12 ga. And fully welded.
Racking: Fully welded one piece shelving is removable for
cleaning.
Tray configuration: (IMC-48)= 12 level, 2 columns, 2 trays
deep. (IMC-72)=18 level, 2 columns, 2 trays deep.
(IMC-144)=13 level, 2 columns, 2 trays deep behind each door,
(2 doors)
Specifications
Note: in line with its policy to continually improve its products, Crimsco Inc. reserves the right to change materials and specifications without notice
/
