Chief PAC124S Installation guide

Chief
Brand
Chief
Model
PAC124S
Category
Mounting kits
Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTIONS
CHIEF MANUFACTURING INC.
1-800-582-6480 952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378 USA
8807-000048
2006 Chief Manufacturing
www.chiefmfg.com
04/06
BEFORE YOU BEGIN
24" Stud Kit
Model: PAC-124
The Chief PAC-124 is used to extend the wood stud
mounting options of the Chief PDR, PNR and PWR,
MWR, and MWH series mounts out to 24" stud enters.
24"
WARNING: It is the installer’s responsibility to make sure all components are properly assembled and installed using
the instructions provided. Failure to read, thoroughly understand, and follow all instructions can result in serious
personal injury, damage to equipment, or voiding of factory warranty.
• If you have any questions about this installation, contact Chief Manufacturing at 1-800-582-6480.
Model: PAC-124 Installation Instructions
2
IMPORTANT WARNINGS AND CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the
instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow
the corresponding instructions.
WARNING: THE MOUNTS THIS KIT CAN BE USED
WITH CAN WEIGH IN EXCESS OF 40 LBS. Use two
people, and proper lifting techniques, when lifting and
positioning the mount.
INTRODUCTION
TOOLS REQUIRED FOR INSTALLATION
• No Tools required for this installation
PARTS
Unpack carton, inspect and verify contents. Read
installation instructions completely. If any listed parts are
missing, contact a Chief Customer Service
Representative at 1-800-582-6480.
Table 1: Parts
Ref. Description QTY
10 BRACKET, Wall Channel, 24" stud centers 2
20 COVER, Wall Channel, 24" stud centers 2
30 CAP, End, R.H. 2
40 CAP, End, L.H. 2
Figure 1: Parts
10
20 30
40
Installation Instructions Model: PAC-124
3
KIT INSTALLATION
16" End Cap, Channel Cover and Wall Channel Removal
1. Carefully lay mount assembly down on back.
2. Firmly grasp four end caps and pull outward, away from mount. (See Figure 2)
3. Slide wall channel cover and pull outward, away from mount. (See Figure 2)
Figure 2: 16" Channel Cover and End Cap Removal (faceplate removed for clarity)
4. Remove four HHCS and four FW securing upper and lower wall channels to mount. (See Figure 3)
5. Set hardware aside for reuse.
Figure 3: 16" Wall Channel Removal (faceplate removed for clarity)
24" Wall Channel, End Cap, and Channel Cover Installation
1. Secure 24" upper and lower wall channels to mount using four FW and four BHCS set aside during 16" wall channel
removal. (See Figure 4)
2. Tighten all screws.
16" Wall Channel
16" Wall Channel Cover
16" Wall Channel
16" Wall Channel Cover
End Cap
End Cap
16" Wall Channel
16" Wall Channel
Flat Washer
Hex Head Cap Screw
Flat Washer
Hex Head Cap Screw
Model: PAC-124 Installation Instructions
4
Figure 4: Install 24" Wall Channel
3. Install mount following the instructions provided with mount.
IMPORTANT ! : Mounting holes must be located based upon 24" stud centers when installing mount.
4. Install 24" upper wall channel cover by tipping cover top down and positioning as shown in STEP A of figure 5 below.
5. Lower bottom of upper wall channel and tap firmly across bottom of channel to lock in place as shown in STEP B of
figure 5 below.
6. Install R.H. and L.H. end caps by aligning tabs on end caps with slots in wall channel and sliding tabs into channel
until end cap is flush with wall channel cover. (See Figure 5)
7. Repeat steps 4 through 6 above for lower wall channel cover and end caps.
Figure 5: Install 24" Uppert and Lower Wall Channel Covers
24" Wall Channel
Flat Washer
Hex Head Cap Screw
Flat Washer
Hex Head Cap Screw
24" Wall Channel
24" Wall Channel
End Cap
End Cap
End Cap
End Cap
Wall Channel Cover
Wall Channel Cover
Upper Wall Channel
Channel Cover
Lower Wall Channel
Channel Cover
Wall
A
B
B
A
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Chief PAC124S Installation guide

Chief
Brand
Chief
Model
PAC124S
Category
Mounting kits
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents