Broan FG7T(C,L) - VS Installation guide

Type
Installation guide

This manual is also suitable for

Addendum
The table below is an addendum to the Installation Instructions and replaces table 16 on
page 48. This table must be used anywhere a reference to Table 16 appears in the Installation
Instructions.
DO NOT use the table on page 48 of the Installation Instructions!
This addendum applies only to the *TC/*TL Two-Stage Condensing Furnaces.
Table 16. Vent Pipe Lengths
FURNACE
MODELS
(BTU)
FURNACE
INSTALLATION
SINGLE PIPE LENGTH (FT.)
with 1 long radius elbow**
DIRECT VENT,
DUAL PIPE LENGTH (ft.) WITH
1 long radius elbow on each pipe**
OUTLET OUTLET INLET/OUTLET INLET/OUTLET
2” Diameter 3” Diameter 2” Diameter 3” Diameter
60,000
Upfl ow 90 90 90 90
Horizontal 50 90 50 90
Downfl ow 30 90 30 90
80,000
Upfl ow 90 90 90 90
Horizontal 30 90 30 90
Downfl ow 90 90 80 90
100,000
Upfl ow 60 90 60 90
Horizontal 30 90 30 90
Downfl ow 30 90 25 90
120,000
Upfl ow N/A 90 N/A 90
Horizontal N/A 90 N/A 90
Downfl ow N/A 90 N/A 90
*NOTES:
1 Subtract 2.5 ft. for each additional 2 inch long radius elbow, 5 ft. for each additional 2 inch short radius elbow, 3.5 ft. for each additional 3
inch long radius elbow, and 7 ft. for each additional 3 inch short radius elbow. Subtract 7ft for each 2” tee and 13ft for each 3” tee.
2. Two 45 degree elbows are equivalent to one 90 degree elbow.
3. This table applies for elevations from sea level to 2,000 ft. For higher elevations, decrease pipe lengths by 8% per 1,000 ft of altitude.
**ATTENTION INSTALLERS**
708939B (Replaces 708939A)
Specifi cations and illustrations subject to change with-
out notice and without incurring obligations. Printed in
U.S.A. (07/08)
O’Fallon, MO
708939B
¢708939]¤
  • Page 1 1

Broan FG7T(C,L) - VS Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI