Linklike Linklike Fly 9 Neckband Earbuds User manual

  • Hello! I am an AI chatbot trained to assist you with the Linklike Linklike Fly 9 Neckband Earbuds User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CAUTION
Use the Bluetooth earphones in the environment with the temperature between
-0 and 45.
The product shall only be connected to a USB interface of version USB 2.0 or
higher and that the connection to a power USB is prohibited.
For battery: risk of explosion battery is replaced by an incorrect type, dispose of
used batteries according to the instructions.
To prevent possible hearing damage, do not listen at high volume levels for long
periods.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT SAFETY INFORMATION
Don't remove or replace the battery, including sensitive electronic components, including a
battery, and can be damaged or cause injury if dropped, burned, punctured, crushed,
disassembled, or if exposed to excessive heat or liquid. Don't use damaged batteries and
electronic components.
Disposal and recycling information
Don't treat the product and battery as household waste or into a fire. When you decide to
dispose of the product and its battery, please follow the local environmental laws to handle
the battery to avoid an explosion.
Medical device interference
The product contains components and radios that emit electromagnetic fields and also
contains magnets. These electromagnetic fields and magnets may interfere with
pacemakers, defibrillators, or other medical devices. Maintain a safe distance of separation
between your medical device and product. Consult your physician and medical device
manufacturer for information specific to your medical device. Stop using the product if you
suspect it is interfering with your pacemaker, defibrillator, or any other medical devices.
BUTTON CONTROLS RESETPRODUCT OVERVIEW
After the first connection, these earphones will automatically reconnect to the
previous device after powering on.
Earphones will automatically power off 5 minutes later without any operation after
powering on.
POWER ONOFF AND PAIRING
Clear the pairing history of "Fly 9" in your device's Bluetooth setting.
When the earphones are on, long press the volume-down and volume-up buttons for
about 5 seconds until the purple light flashes.
Earphones enter into pairing mode when red and blue lights flash alternately.
Go to the Bluetooth setting in your device, find and tap "Fly 9" to connect.
1.
2.
Step 1.
Step 2.
Step 3.
Step 4.
Fly 9 Neckband Bluetooth Earphones
User Manual
L
Write to support@linklike-audio.com
Contact us for any questions:
Fly 9 Neckband Bluetooth Earphones
First-time pairing: long press the multi-function button for about 2 seconds until "power
on" voice prompts, then the earphones enter into pairing mode. Go to the Bluetooth
setting in your device, find and tap "Fly 9" to connect.
Please fully charge the earphones before the first use. Recharge the earphones when
"Battery Low" voice prompts.
Function
To power on
To power off
Connected
Connection Failed
Current Status
Power off mode
Power on mode
N/A
N/A
Operation
N/A
N/A
LED Indicator
Purple light flashes
Purple light flashes
N/A
N/A
Voice Prompt
Power on
Power off
Connecting
Connection failed
Notes:
Voice Prompt
N/A
Maximum volume: beep
Minimum volume: beep
N/A
N/A
Beep
Beep
Play/Pause music
Volume up
Volume down
Next track
Previous track
Answer/Hang up calls
Reject calls
Function Operation
Music
Calls
SPECIFICATIONS
Linklike is a trademark registered in the USA and other countries. All rights reserved.
WARRANTY CARD
CHARGING
Battery Low
Charging
Fully Charged
Red light flashes
Solid red light
Solid blue light
LED IndicatorStatus
Fit isssue
Pairing issue
Cut-in/Cut-off issue
Sound quality
Call issue
Battery/Charging issue
Quality related issue
Others
1. Ear tips
2. Left earbud
3. Right earbud
4. Volume-up button
5. Multi-function button
6. Volume-down button
7. LED indicator
8. Micro USB charging port
9. Battery
10. Microphone is behind the Volume-up button
Long press the
multi-function button
for about 2 seconds
Long press the
multi-function button
for about 3 seconds
Function
To enter pairing mode
Current Status
Power off mode
Operation
LED Indicator Voice Prompt
Pairing
Red and blue lights
flash alternately
Long press the
multi-function button
for about 5 seconds
Press the multi-function button once
Press the volume-up button once
Press the volume-down button once
Long press the volume-up button for about 2 seconds
Long press the volume-down button for about 2 seconds
Press the multi-function button once
Long press the multi-function button for about 2 seconds
Listening Responsibility
To avoid hearing impairment, please make sure to turn down the volume of the music
player before connecting the earphones. After putting the earphones into/onto the ears,
turn up the volume gradually until to a comfortable listening level. Noise level is measured
in de- cibels (db). Exposure to 85db or higher noise will lead to gradual hearing impairment.
Please supervise your usage and the hearing impairment is a function of loudness against
time. The louder the sound is, the shorter you can be exposed. The softer the sound is, the
longer you can listen.
If you want to connect the earphones to another device,
Please fully charge the earphones before the first use.
Warranty Period: 12 Months
Email us to enroll our VIP program and gain an extra half a year warranty.
support@linklike-audio.com
linklike-audio.com
6mm
20~20000Hz
105±3dB
32Ω
Speaker size
Frequency range
Sensitivity
Impedance
Battery capacity
5.0
≤ 33 ft
≈ 3 hrs
≈ 16 hrs
≈ 480 hrs
0~45
Bluetooth version
Transmission range
Charging time
Music play time/Talk time
Standby time
Working Temperature
Li-Polymer Battery
3.7V/250mAh
Fly 9 Neckband
Bluetooth
Earphones
Lithium Battery
Charging Limited
Voltage
4.2V
Product name Model Fly 9
Made in China
* Based on the test results of Linklike Lab, for reference only.
/