Trianium 5823838126 User guide

Brand
Trianium
Model
5823838126
Category
Mobile phone cases
Type
User guide
Duranium Case for iPhone Xr
- OVERVIEW -
Microphone hole
Silence Switch
Enclosed Volume Buttons
Soft Outer TPU Case
Scratch Resistant Clear Case
Cover with Screen Protector
Polycarbonate Swappable
Cover
Dust and Water-Resistant
Charging Port Cover
1 6
7
2
3
4
5
1
23
4
5 6
7
1
Begin by separating the backplate from the soft body of
the case.
2
Remove all protective lm from case.
Peel Off
3
Starting from the corner, remove the soft TPU casing from
the cover piece.
Peel Off
Soft Outer TPU Case
5
Press all around the sides and corners of the case
making sure the cover is completely sealed in.
6
4
Place the phone into the cover piece with the screen facing
the transparent window.
iPhone
Hard Cover
5
Working your way from the bottom, join the soft
casing and cover back together. Make sure all ports
and buttons are correctly aligned.
iPhone
Hard Cover
7
Insert the backplate starting from the bottom of the case.
8
Complete by then attaching the top two corners of the
backplate to the soft case.
- INSTALLATION -
Page 1/2
USING THE HOLSTER
1
Slidzphone into the holster. Make sure to
have the screen facing inward to avoid
scratches when walking.
2
Gently snap the other side of the case into
the holster. Make sure you feel the snap to
ensure the case is locked into place.
PHONE CASE
HOLSTER
UNINSTALL
Use one hand to gently pull up on the holster’s
release tab while the other hand gently pulls the
case away from the holster.
USING THE KICKSTAND
PHONE CASE
HOLSTER
While holding the clip open, slide down the
locking mechanism to engage the lock for easy
viewing, directly from the holster.
Duranium Case for iPhone Xr
1
Begin by separating the backplate from
the soft body of the case.
2
Gently pull away the rubber lip from the
top piece of the case starting from the
lower left corner.
Peel Off
Soft Outer TPU Case
Slightly Pullout the Corner
4
Working your way from the bottom, join the
soft casing and cover back together. Make
sure all ports and buttons are correctly
aligned.
3
Slowly separate the two pieces of the
case, then remove the iPhone from the top
piece of the case as shown.
iPhone
Hard Cover
5
Press all around the sides and corners
of the case making sure the cover is
completely sealed in.
6
Insert the backplate starting from the
bottom of the case.
7
Complete by then attaching the top
two corners of the backplate to the soft
case.
- UNINSTALL -
Page 2/2
  • Page 1 1
  • Page 2 2

Trianium 5823838126 User guide

Brand
Trianium
Model
5823838126
Category
Mobile phone cases
Type
User guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents