Maytag MTB1976HRB Installation guide

Type
Installation guide

This manual is also suitable for

(O LEVELERS) (O HANDLING)
ALL THE WAY IN
t_/_ REMOVE CRATE
BASE SCREWS &
II I_D---_ CRATE
_. BASE
(0 REFRIGERATOR LEVELING)
MOVE THE REFRIGERATOR TO ITS INSIDE LOCATION.
(1) avelthecabinet. Openandclosethedoors,
Re-level the cabinet.
(2) If the cahinet rolls, extend the levelers.
{3) If the doors do not close easily, raise the front of
the cabinet,
TO LOWER
Leveler
TO RAISE
Leveler
TRUCK FROM
LEFT SIDE
The refrigerator should remain
upright for at least 30 minutes
prior to plugging it in.
(_Q DOOR ADJUSTMENT (IF NEEDED) )
Loosen
screws 5/16.___,_._
- 0R-
DO NOT
REMOVE
PAD THE
CORNERS
Loosen
t
!
Loosen 5/16"
t acrGws__
_16"
LOOSEN SCREWS AND SLIDE
LEFT TO _ DOORS.
°®
5/16"
LOOSEN SCREWS AND SLIDE
_ OL_ DOORS.
FULLY TIGHTEN ALL SCREWS,
SAVE THE DOOR SPACER, DOORS
MAY SETTLE WITH USE.
110926-2
CREMOVING DOORS (IF REQUIRED)_
5/16"
REST DOOR ON A
NON-SCRATCHING
SURFACE
O
WASHER(s)
(Notelocatlons)
OPENDOOR
AND LIFT
(Do not discard)
(A) REMOVE
LEFT SCREW
(B) SLIDE DOOR AND
HINGE PAST RIGHT
SCREW
REST DOOR ON A
NON-SCRATCHING
SURFACE
. H
N
5116"
HINGE
REPLACING DOORS
Replace doors in reverse order of their removal, Align doors using the door
spacer.
C
DOOR REVERSAL
BEFORE
LOWER HINGE
)
HANDLES
110926-2
  • Page 1 1
  • Page 2 2

Maytag MTB1976HRB Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI