Reese 58306† Installation guide

Reese
Brand
Reese
Model
58306†
Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTIONS
PLYMOUTH, MI.
CHAIN HANGER
CLAMP ON
CHAIN HANGER
BACK PLATE
CARRIAGED
BOLT
LOCK NUT
SPRING CLIP
LOOSE LINKS
LINKS TO
SPRING BAR
FIG. 1
FIG. 2
INSTALLING CHAIN HANGER:
1. INSERT ONE CARRIAGE BOLT THROUGH TOP HOLE IN CHAIN HANGER (SEE FIG. 1) AND IN TOP HOLE
OF BACK PLATE. THREAD LOCK NUT ON CARRIAGED BOLT.
2. HANG THE ASSEMBLY OVER THE TRAILER FRAME APPROX. 31” FROM THE CENTER OF COUPLER
BALL CENTER TO CENTER OF CHAIN HANGER. NOTE: CHAIN HANGER MIGHT NEED TO MOVE FORE
AND AFT, TO ALLOW SPRING BAR CHAIN TO BE VERTICAL.
3. INSERT SECOND CARRIAGED BOLT THROUGH CHAIN HANGER HOLE AND BACK PLATE HOLE THAT IS
THE NEAREST TO THE BOTTOM OF TRAILER FRAME.
4. TIGHTEN LOCK NUT EVENLY SO THE CHAIN HANGER AND BACK PLATE ARE TIGHT AGAINST THE
TRAILER FRAME. CAUTION
: DO NOT OVER TIGHTEN NUTS AND BOLTS, MAY CAUSE DAMAGE TO
TRAILER FRAME.
5. REPEAT STEP 1 THRU 4 FOR OTHER SIDE.
HOOK UP:
1. HOOK UP TOW VEHICLE AND TRAILER. (CONSULT W.D. INSTRUCTIONS FOR HOOK UP)
2. PLACE SPRING BAR IN W.D. HEAD. (CONSULT W.D. INSTRUCTIONS FOR HOOK UP)
3. RAISE TRAILER TONGUE AND REAR OF CAR WITH JACK. NOTE: PLACE WOOD BLOCK UNDER JACK
FOR EXTRA HEIGHT AND CONFIRM TRAILER IS STABLE.
4. SLIP THE CLOSEST LINK OVER THE CHAIN HANGER HOOK. NOTE: MAKE SURE LOOSE LINKS ARE AT
BOTTOM OF LINKS THAT IS HOOKED IN PIN. (SEE FIG. 2) (IF THERE ARE LESS THAN 5 LINKS
BETWEEN HOOK AND U-BOLT ADJUST BALLMOUNT ANGLE REARWARD, AND REPEAT PROCEDURE).
PLACE SPRING CLIP IN TO CHAIN HANGER HOOK HOLE.
5. REPEAT FOR OTHER SIDE.
6. CONSULT W.D. INSTRUCTIONS FOR THE REST OF THE HOOK UP.
For Installation Assistance or Technical Help, Call 1-888-521-0510
58306IN-20JUL06A PCN8854 ©2006 TOWING PRODUCTS, INC Litho in USA
  • Page 1 1

Reese 58306† Installation guide

Reese
Brand
Reese
Model
58306†
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents