Philips S5510/45 User manual

Page is loading ...

6

Introduction

Congratulations on your purchase and welcome

to Philips! To fully benet from the support

that Philips offers, register your product at

www.philips.com/welcome.

Please read this user manual, as it contains

information about the wonderful features of this

shaver as well as some tips to make shaving easier

and more enjoyable.

General description (Fig. 1)

A Protection cap

B Shaving unit

C Shaving unit release button

D Shaver on/off button

E Charging light

F Trimmer (PT860 only)

G Trimmer release slide (PT860 only)

H Cleaning brush

I Adapter

Note: You can nd the type number on the back of

the shaver.

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

Danger

- Make sure the adapter does not get wet.

Warning

- The adapter contains a transformer. Do not cut

off the adapter to replace it with another plug, as

this causes a hazardous situation.

ENGLISH

- The appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience

and knowledge, unless they have been given

supervision or instruction concerning use of the

appliance by a person responsible for their safety.

- Children should be supervised to ensure that they

do not play with the appliance.

- Always unplug the shaver before you clean it under

the tap.

Caution

- Never immerse the shaver in water.

- Do not use the shaver in the bath or in the shower.

- Never use water hotter than 80°C to rinse the

shaver.

- Be careful with hot water. Always check if the water

is not too hot, to prevent your hands from

getting burnt.

- The shaver is not dishwasher-proof.

- Water may leak from the socket at the bottom of

the shaver when you rinse it. This is normal and not

dangerous because all electronics are enclosed in

a sealed power unit inside the shaver.

- Do not use the shaver, adapter or any other part if

it is damaged, as this may cause injury. Always

replace a damaged adapter, charger or part with

one of the original type.

- Use, charge (specic types only) and store the

appliance at a temperature between 10°C and 35°C.

- Always place and use the shaver on a surface that

is uid-resistant.

- Only use the adapter, charger and accessories

supplied.

- Always put the protection cap on the shaver

to protect the shaving heads when you are travelling.

ENGLISH 7

Compliance with standards

- The shaver complies with the internationally

approved IEC safety regulations and can be safely

cleaned under the tap.

- The shaver complies with all standards regarding

electromagnetic elds (EMF). If handled properly

and according to the instructions in this user

manual, they are safe to use based on scientic

evidence available today.

General

- The appliance is equipped with an automatic

voltage selector and is suitable for mains voltages

ranging from 100 to 240 volts.

- The adapter transforms 100-240 volts to a safe

low voltage of less than 24 volts.

Charging

PT860: It takes approx. 1 hour to fully charge the

shaver.

PT735/PT730/PT725/PT720: It takes approx. 8 hours

to fully charge the shaver.

When you charge the shaver for the rst time or

after a long period of disuse, let it charge until the

charging light lights up continuously.

A fully charged shaver provides up to 17 (PT860) or

14 (PT735/PT730/PT725/PT720) cordless shaves.

The shaving time may be less than 17 (PT860) or

14 (PT735/PT730/PT725/PT720) cordless shaves

as a result of your shaving behaviour, your cleaning

habits or your beard type.

ENGLISH8

Charge indications

Battery low

- When the battery is almost empty (when there

are only 5 or fewer shaving minutes left), the

charging light starts to ash orange.

- When you switch off the shaver, the charging light

continues to ash orange for a few seconds.

Quick charging

- When you start charging the empty battery,

the charging light alternately ashes orange and

green. After approx. 3 minutes, the charging light

continues to ash green. The shaver now contains

enough energy for a 5-minute shave.

Charging

- When the shaver is charging, the charging light

ashes green.

Battery fully charged

- When the battery is fully charged, the charging

light lights up green continuously.

Note: After approx. 30 minutes, the charging light goes

out to save energy.

Charging with the adapter

1 Put the small plug in the shaver.

2 Put the adapter in the wall socket.

, The charging light shows the charging status of

the shaver (see section ‘Charge indications’ in

this chapter).

ENGLISH 9

Using the shaver

Note: You can also use the shaver directly from the

mains. Simply connect the shaver to the mains.

Shaving

1 Press the on/off button once to switch on the

shaver.

2 Move the shaving heads over your skin. Make

circular movements.

- Do not make straight movements.

- Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

3 Press the on/off button once to switch off the

shaver.

4 Clean the shaver (see chapter ‘Cleaning and

maintenance’).

Trimming (PT860 only)

You can use the trimmer to groom your sideburns

and moustache.

1 Press the on/off button once to switch on the

shaver.

2 Push the trimmer slide downwards to open

the trimmer.

, You can now start trimming.

3 After trimming, close the trimmer and switch

off the shaver.

ENGLISH10

Cleaning and maintenance

Never use compressed air, scouring pads, abrasive

cleaning agents or aggressive liquids such as petrol

or acetone to clean the appliance.

- Clean the shaver after every shave for optimal

shaving performance.

- Regular cleaning guarantees better shaving

performance.

- For the best cleaning results, we advise you to use

the Philips Cleaning spray (HQ110).

- Be careful with hot water. Always check if the

water is not too hot, to prevent your hands from

getting burnt.

Note: Water may leak from the socket at the bottom

of the shaver when you rinse it. This is normal and not

dangerous because all electronics are enclosed in a

sealed power unit inside the shaver.

Cleaning the shaving unit under the tap

1 Switch off the shaver and disconnect it from

the mains.

2 Press the release button to open the shaving unit.

3 Rinse the shaving unit and hair chamber under

a hot tap for 30 seconds.

Be careful with hot water. Always check if the

water is not too hot, to prevent your hands from

getting burnt.

ENGLISH 11

- Rinse the hair chamber and the inside of the

shaving unit.

- Rinse the outside of the shaving unit.

4 Close the shaving unit and shake off excess

water.

Be careful not to hit the shaving unit against

anything while shaking off excess water.

Never dry the shaving unit and the hair chamber

with a towel or tissue, as this may damage the

shaving heads and the coupling spindles.

5 Open the shaving unit again and leave it open

to let the shaver dry completely.

Cleaning the shaving unit with the cleaning

brush

1 Switch off the shaver and disconnect it from

the mains.

2 Press the release button to open the shaving

unit.

3 Pull the shaving unit off the shaver.

ENGLISH12

4 Turn the lock anticlockwise (1) and remove the

retaining frame (2).

5 Remove and clean one shaving head at a time.

Each shaving head consists of a cutter and a

guard.

Note: Do not clean more than one cutter and guard

at a time, since they are all matching sets. If you

accidentally mix up the cutters and guards, it may take

several weeks before optimal shaving performance is

restored.

- Remove the cutter from the shaving guard and

clean it with the brush.

- Clean the inside and outside of the shaving guard

with the brush.

6 Put the shaving heads back into the shaving unit.

ENGLISH 13

PT860/PT735/PT730: Make sure that the projections

of the shaving heads t exactly into the recesses.

7 Put the retaining frame back into the shaving

unit and turn the lock clockwise.

8 Insert the lug of the shaving unit into the slot

in the top of the shaver (1). Then close the

shaving unit (2).

Note: If the shaving unit does not close smoothly, check

if you have inserted the shaving heads properly and if

the retaining frame is locked.

Cleaning the trimmer with the cleaning

brush (PT860 only)

Clean the trimmer every time you have used it.

1 Switch off the shaver and disconnect it from

the mains.

2 Push the trimmer slide downwards to open

the trimmer.

3 Clean the trimmer with the short-bristled side

of the cleaning brush. Brush up and down along

the trimmer teeth.

4 Close the trimmer (‘ click’).

Tip: For optimal trimming performance, lubricate the

trimmer teeth with a drop of sewing machine oil every

six months.

ENGLISH14

Storage

- Put the protection cap on the shaver every time

you have used it, to prevent damage.

Replacement

For maximum shaving performance, we advise you

to replace the shaving heads every year.

Replace damaged shaving heads right away.

Only replace the shaving heads with original HQ8

Philips Shaving Heads.

1 Switch off the shaver and disconnect it from

the mains.

2 Press the release button to open the shaving

unit.

3 Pull the shaving unit off the shaver.

4 Turn the lock anticlockwise (1) and remove the

retaining frame (2).

5 Remove the shaving heads and place new ones

in the shaving unit.

Make sure that the projections of the shaving

heads t exactly into the recesses.

6 Put the retaining frame back into the shaving

unit and turn the lock clockwise.

ENGLISH 15

7 Insert the lug of the shaving unit into the slot

in the top of the shaver (1). Then close the

shaving unit (2).

Note: If the shaving unit does not close smoothly, check

if you have inserted the shaving heads properly and if

the retaining frame is locked.

Accessories

To retain the top performance of your shaver, make

sure you clean it regularly and replace its shaving

heads at the recommended time.

Shaving heads

- We advise you to replace your shaving heads

every year. Always replace with HQ8 shaving

heads.

Cleaning

- Use Cleaning spray (HQ110) to clean the shaving

heads thoroughly.

Environment

- Do not throw away the appliance with the normal

household waste at the end of their life, but

hand them in at an ofcial collection point for

recycling. By doing this, you help to preserve the

environment.

- The built-in rechargeable shaver battery contains

substances that may pollute the environment.

Always remove the battery before you discard or

hand in the shaver at an ofcial collection point.

Dispose of the battery at an ofcial collection

point for batteries. If you have trouble removing

ENGLISH16

the battery, you can visit our website,

www.philips.com/support or call toll free: 1-866-

800-9311.

Removing the rechargeable shaver battery

Only remove the rechargeable battery when you

discard the shaver. Make sure the rechargeable

battery is completely empty when you remove it.

1 Disconnect the shaver from the mains.

2 Let the shaver run until it stops.

3 Undo the screws in the back of the shaver and

in the hair chamber.

4 Remove the front panel and the back panel.

5 Bend the 6 hooks aside and take out the

power unit.

Be careful, the hooks are sharp.

6 Remove the battery.

Be careful, the battery strips are sharp.

Do not connect the shaver to the mains again after

you have removed the rechargeable battery.

Guarantee and service

If you need service or information or if you have a

problem, please visit the Philips website at

www.philips.com or contact the Philips Consumer

Care Centre toll free at 1-866-800-9311.

Guarantee restrictions

The shaving heads (cutters and guards) are not

covered by the terms of the international guarantee

because they are subject to wear.

ENGLISH 17

Troubleshooting

This chapter summarises the most common

problems you could encounter with the appliance. If

you are unable to solve the problem with the

information below, contact the Consumer Care

Centre in your country.

Problem Possible cause Solution

The shaver does

not shave as well

as it used to.

The shaving

heads are

damaged or

worn.

Replace the shaving heads (see

chapter ‘Replacement’).

Long hairs

obstruct the

shaving heads.

Clean the shaving heads one by

one (see section ‘Cleaning the

shaving unit with the cleaning

brush’ in chapter ‘Cleaning and

maintenance’).

You have not

inserted the

shaving heads

properly.

Make sure that the projections of

the shaving heads t exactly into

the recesses (see section ‘Cleaning

the shaving unit with the cleaning

brush’).

The shaver does

not work when I

press the on/off

button.

The

rechargeable

battery is

empty.

Recharge the battery (see chapter

‘Charging’) or connect the

shaver to the mains.

The

temperature

of the shaver

is too high. In

this case, the

shaver does

not work.

As soon as the temperature of the

shaver has dropped sufciently, you

can switch on the shaver again.

ENGLISH18

Page is loading ...

Philips S5510/45 User manual

Philips S5510/45 User manual

in other languages

Related papers

Other documents