Page is loading ...
Mini compound vice
Manual Instruction
Mini Compound Vice Instructions
Valued customers,
Thanks for your purchasing our products, and hope our products would bring convenience and
happy to your life and working.
This multi-function mini compound vice can work together with bench drill and mill machine
to get precision compound drilling or milling works. Please follow relative operation and
safety instructions of bench drill or mill machine you would use.
And please noted that this mini compound vice is precision, lightly duty, and it would be
damaged if abuse.
Please keep your normal mind when operation and use safety equipment to ensure your safety.
Technology data：
X-travel： 80mm
Y-travel： 67mm
Vice capacity：75mm
One round scale: 1.5mm
General view:
Fig. 1
Base
Vise body
Movable vise
Table supporter
Handwheel
Scale ring
Adjusting screw
Cutting Cover
Thread rod
WARNING
Please do not overload it, otherwise it will be prone to deformation, loose and other damage and
dangerous accidents.
【Mounting】
1. Mounting compound vise
The compound vise was designed for use with mini bench drill or mill machine.The compound
vise can now be fastened to the work surface using the M8 threaded holes and the mounting
stones.
【Operating】
1. Setting the scale
The scale rings on the handwheels are moveable and can be set to zero without traversing the table. In addition to the
scale rings, the compound table is equipped with a moveable scale for adjustment in the X direction.
2. Adjusting the guide play
If, after a time, the compound table guide is found to have too much or too little play, the play can be reset using the
adjusting screws. In order to adjust the play in the X direction, first release the nut, then set the play using the set screw,
Lock by re-tightening nut. Adjustment of play in the Y direction is performed analogously.
(Note: Do not over-tighten the set screws as the guide will be damaged.)
3. Feed speed and working depth
When machine different materials, apply different feed speed and working depth. Over load
and fast feed speed would be damaged to this compound vise or machines.
Note: mountain this compound vise after using it, remove dust and waterlogging.
Parts list
1
Thread rod Tr14×130
14
Shorter thread rod
27
Base
2
Fix screw M5x8
15
Thread rod bush
28
Base slide support
3
Movable vise
16
Scale ring
29
Spring washer 5
4
Slide bar
17
O ring
30
Screw M5×16
5
Nut cap
18
Column pin
31
Hex nut M4
6
Hex nut M10
19
Handwheel
32
Screw M4×12
7
Slide bearing
20
Hand lever
33
Longer thread rod
8
Screw M5×10
21
Screw M5×51
34
Body right cover
9
Body left cover
22
Screw ST3×10
35
Vise body
10
Thread slide nut M10
23
Screw ST4×16
36
Vise rubber cover
11
Upper adjust plate
24
End cover
37
Vise teeth
12
Table supporter
25
Lower cut cover
38
Screw M5×10
13
Lower adjust plate
26
Upper cut cover
39
/
