PROPOINT 9118001 Owner's manual

9118001

V1.0

HOW TO USE DESOLDERING PUMP?

HOW TO USE SOLDERING IRON KIT? IDENTIFICATION KEY

Please note it may happen that if the wire is not straight inside

the solder, simply it does not ﬁnd the way to exit, but is bundled

inside.

You may try to open the cover of the gun at side and see where

the wire is. At that point you may cut the soldering wire and

restart to feed it. If this way could not solve the issue, please ask

for replacement.

Fig.01 Fig.02

Fig.03 Fig.04

HOW TO SOLVE A POSSIBLE ISSUE THAT THE GUN DOESN'T FEED?

Step 1 Totate the nut and straighten the tin wire. (Fig.01)

Step 2 Insatall the cilp and tin wire. (Fig.02)

Step 3 Pass the tin wire in a straight line to the tip of the

soldering iron. (Fig.03)

Step 4 Pull the trigger for tin-out. (Fig.04)

Step 1 Press the plunger down until a clicked sound.

(Fig.05)

Step 2 Heating the solder unilt it melts and place the

sucker next to it. (Fig.06)

Step 3 Press the release button to remove the melt

solder. (Fig.07)

Step 4 Repeat it if you need. (Fig.08)

A Power Switch

B Charging Interface

Fig.05 Fig.06

Fig.07

Fig.08

148 mm

(5.83 in)

148x210mm (5.83x8.27 in.)

210 mm

(8.27 in)

Download PDF