12
Operation Instructions
HearthCabinet™VentlessFireplacesprovideasafewaytoenjoyarefeaturewhenusedproperly.
Never,underanycircumstances,modifyoralteranypartofthereplaceorfuelcartridges.Modifying
oralteringtheproductsmaymakethesystemunsafeand/orcauseare.TheAlcoholGelFuel
Cartridgesaresingle-useandshouldNEVERberelled.
To light the Natural Flame Fuel Cartridge™:
1) Open the locked front screen door of the HearthCabinet Ventless Fireplace with provided keys.
2) Place one or two unopened fuel cartridges in the cartridge holder, rubber cap end up, so that the
cartridgeissittingatandlevel.
3) Once the cartridge(s) have been placed into the cartridge holder carefully remove the rubber
cap(s)fromthecartridge(s)toexposethealcoholgelfuel.
4) Make sure that no gel spills, splatters, or ends up outside the cartridge. If it does, wipe the
surface(s) clean with a damp towel and let dry completely before attempting to light the cartridge.
5)Withalonglighter,lightthegelfuelbybringingtheameclosetothegel.Donotstickthelighter
intothegel.Iflitgelgetsonthelighter,keepthelighterstillandawayfromanyammableobjects
ormaterialsandwaituntilthelitgelextinguishesitself.IMPORTANT:DONOTputinone
cartridge, light it, and then put in another. Put both in, and then light both.
6) Close and lock the protective screen door.
To extinguish the Natural Flame Fuel Cartridge™:
Theamefromthecartridge(s)willgooutonitsownwhenthefuelisusedup.Tomanuallyextinguish
the cartridge(s), carefully sit the metal snuffer plate(s), one for each cartridge, on the top of the
cartridgeuntiltheamehasgoneout.
Unlock the door and keep the door held open
with one hand.
With the other hand, grab one snuffer plate
and gently sit it on the top of the cartridge,
makingsurethatamesnolongercomeout
of the cartridge.
If burning more than 2 cartridges at a time;
leaverstsnufferplateinplace,andfollowthe
same procedure with the other snuffer plate.
Leave snuffer plate(s) on top of the
cartridge(s)untilnoamecanbeseen.
Allow cartridge(s) to cool down before
replacing/removingitfromtheunit(min.30
mins), replace rubber cap(s) and discard.
place logs around the cartridge slot logs should not block or interfere
1
3
2
4
1.
2.
3.
4.
5.