Pi Tape Digital Battery Change Operating instructions

Hello! I've reviewed the provided instructions for changing the battery in the digital device. The document explains how to use a scribe to remove the old battery and outlines how to install a new CR2032 battery. I'm ready to answer your questions about this process.
What tool should I use to remove the old battery?

What tool should I use to install the new battery?

What is the part number for the battery?

Instructions for Battery Change:

The top surface of the black digital housing has a small hole in it through which a small pointed

scribe can be used to remove battery.

Insert the pointed end of scribe into the hole and press it against the battery.

Next, pivot the scribe so that the battery will slide towards the open slot in the black casing

and remove the old battery.

To install a new battery, use a small pair of needle nose pliers (or tweezers) to grasp the

battery at its edges and carefully push the battery into the slot, with the + symbol facing upward.

Part number for battery is CR2032.

ADVISORY: Should any repairs be needed, please contact us.

DIGITAL BATTERY CHANGE

PI TAPE and the logo are trademarks of Pi Tape Texas, LLC, and they are registered in the USA and in 45 other countries.

Please visit https://www.pitape.com/trademarks.htm for a list of countries in which our trademarks are registered.

BATTERY SLOT

SCRIBE HOLE

BATTERY SLOT

SCRIBE HOLE

November 2019 Rev A