A Remove all adhesive
tape and the Touchscreen
label. Plug into grounded
outlet.
B Carefully remove Water
Reservoir Lid. Remove
Water Reservoir by lifting
up and away from
the Brewer.
C Rinse Water Reservoir
with fresh water, return
Reservoir to Brewer
and fill to the “MAX FILL”
line with water. Bottled
or filtered water is
recommended.
Step 1 Prepare Water Reservoir
The Keurig
®
Vue
™
Brewer is not for use with K-Cup
®
packs.
Keurig
®
Vue
™
V600 Brewer
Quick Start Guide
Step 3 Brew Your First Beverage
A Place a 10 oz. mug toward
the back of the Drip Tray
and press the Power
Button.
B Once your Brewer is
turned on, wait until the
Touchscreen indicates
“Ready” (about four
minutes).
C Lift and lower the Handle,
then press the flashing
“BREW” Button. Your
Brewer will dispense
8 oz. of hot water into
your mug. Discard the
hot water.
Step 2 Prepare Brewer
4
After brewing certain Vue
™
pack varieties,
we recommend performing a cleansing
brew. Please refer to page 15 of the
Use & Care Guide for instructions.
Caution: Do not lift the Brewer Handle
while heating or brewing.
Do not remove or puncture the lid
of the Vue
™
pack prior to brewing.
After brewing, use caution when
removing the Vue
™
pack, as it will be hot.
A Place your mug on
the Drip Tray. Lift the
Brewer Handle.
B Place your favorite
Vue
™
pack into the Vue
™
pack Holder. Note that
the “spout” of the pack
should face down. Lower
the Brewer Handle.
C If brewing a coffee
Vue
™
pack, choose your
strength and size. If you
prefer a stronger brew,
select “Strong.” Then
select your beverage
size by using the + and -
buttons. Once selected,
press “BREW” and enjoy!
P/N 60-201387-000 Rev B 05/12
/