2. Kmart
  3. 42839491

Kmart 42839491 User manual

  • Hello! I've reviewed the assembly instructions for the 42839491 metal coat stand. This document outlines the necessary parts, tools and steps to assemble your coat stand, which is designed to handle a maximum of 16kg. I'm ready to answer your questions about setting up and using your new coat stand.
  • What is the maximum weight load per hook?
    What is the total maximum safe weight load for the coat stand?
    What tools are needed for assembly?
Care & Use Instructions:
• Keep the coat stand on a level, stable surface during use. This coat stand is for hanging
clothing and clothing accessories only.
• MAXIMUM SAFE WEIGHT LOAD 2KGS PER HOOK, TOTAL 16KGS evenly distributed
Assembly Instructions
Metal Coat Stand
Tools Required:
• Phillips screwdriver (not supplied)
• Spanner (supplied)
over 8 Hooks.
Wipe clean with a soft damp cloth. Never use scourers, abrasives or chemical cleaners.•
Avoid scratching the surface.
Parts Supplied
Ref Description Illustration Qty
G Short Hanger 4pcs
1pc
8pcs
4pcs
4pcs
1pc
H Screw Base
Cover
I Short Screw
Dia 6 x L 15mm
J
K
Long Screw
with Nut
Dia 6 x L 29mm
Screw Foot Pad
L Spanner
Ref Description Illustration Qty
A Top Pole
B Middle Pole
1pc
1pc
1pc
1pc
1pc
4pcs
C Bottom Pole
with Screw
Base
D Upper Stand
E Lower Stand
F Long Hanger
42839491
1. Insert the Long Screw with Nut(J) to connect the Bottom Pole with Screw Base(C) with the Upper
& Lower Stand(D & E), so that the screw holes on the pole and the Stands line up. Tighten screws
using nuts provided. Then insert the four Screw Foot Pad(K) into the Upper & Lower Stands(D & E)
with 4 holes. Use the Screw Base Cover(H) to protect the Bottom Pole(C) and the Screws(J).
2. Insert the Middle pole(B) into the Bottom Pole with Screw Base(C).
3. Insert the Short Hanger(G) and the Long Hanger(F) to the holes of the Top Pole(A) using the Short
Screw(I). Finally, insert the Top Pole(A) into the Middle Pole(B).
Step 1
Step 2
Step 3
Completed
/