INSTALLATION INSTRUCTIONS
Milestone AV Technologies, Inc., and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone
makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation
or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, ex-
pressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this doc-
ument.
© 2008 Chief Manufacturing, 8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8800-000066 Rev.A
1/10/08
Model PAC136 Click-Lock Flag Kit
Unpack carton and verify contents. If any listed parts are missing, immediately contact a Chief Customer Service representative by calling
1-800-582-6480.
B(1)
5/16-18 x 2 3/4"
C(1)
J(1)
H(1)
G(1)
A(1) 10-24 x 3/8"
5/16-18
10-24
3/16"
F(1)
4-40
4-40 x 2 1/2"
D(1)
PARTS INCLUDED TOOLS REQUIRED
#1, #2
Adjustable
INSTALLATION
Install Latch to Faceplate
1. Remove plastic plugs from faceplate. (See Figure 1)
2. Orient latch and secure to back of faceplate using one Phillips
pan head screw (C) and one locknut (B). (See Figure 1)
3. Following the instructions provided with the mount, install and
secure display to faceplate using one Phillips pan head screw
(D) and one lock nut (F) in desired location.
Figure 1:
4. After display installation is complete, additional security can be
provided by installing one button head cap screw (J) and one
lock nut (H), using the 3/16" hex wrench (G) provided.
(See Figure 2)
Figure 2:
(B) x 1
2
(A) x 1
(C) x 1
Back of Faceplate
1
Remove
plastic plugs
(J) x 1
(H) x 1
4
3
(D) x 1 (F) x 1
/