Specifications are subject to change without notice. IE-MLG-MLP006-01
Adapter MLP006
for easy connection U/I signals to Multilogger
www.cometsystem.com
PRODUCT DESCRIPTION
MLP006 adapter is designed for easy connection voltage and current signals to the inputs
of M13xx Multiloggers in those cases, where the connected transmitters require power from
external source.
TECHNICAL PARAMETERS
Terminals CPP3.5
Maximal wire cross-section 1 mm
2
Operating temperature range -10 to +60 °C
Operating relative humidity range 5 to 85 %RH without condensation
Weight 10 g
DIMENSIONS
INSTALATION
connect transmitters and external power supply to the adapter and to the self-locking
WAGO terminal (see Typical application wiring)
if the more transmitters with a common power supply have to be connected to the
Multilogger, use only one adapter MLP006. In this case connect it to the input No.4
TYPICAL APPLICATION WIRING
WARNING
power supply Ucc is used only to
power the transmitters
the shielding of the cables connect
only to the GND terminals of
Multilogger (do not connect it to any
other circuitry and do not ground it)
never use a shielding of the cables as
signal wire
to supplement the information
provided in this data sheet, use the
manuals and other documentations
which are available at address
www.cometsystam.com
Specifications are subject to change without notice. IE-MLG-MLP006-01
Adapter MLP006
for easy connection U/I signals to Multilogger
www.cometsystem.com
PRODUCT DESCRIPTION
MLP006 adapter is designed for easy connection voltage and current signals to the inputs
of M13xx Multiloggers in those cases, where the connected transmitters require power from
external source.
TECHNICAL PARAMETERS
Terminals CPP3.5
Maximal wire cross-section 1 mm
2
Operating temperature range -10 to +60 °C
Operating relative humidity range 5 to 85 %RH without condensation
Weight 10 g
DIMENSIONS
INSTALATION
connect transmitters and external power supply to the adapter and to the self-locking
WAGO terminal (see Typical application wiring)
if the more transmitters with a common power supply have to be connected to the
Multilogger, use only one adapter MLP006. In this case connect it to the input No.4
TYPICAL APPLICATION WIRING
WARNING
power supply Ucc is used only to
power the transmitters
the shielding of the cables connect
only to the GND terminals of
Multilogger (do not connect it to any
other circuitry and do not ground it)
never use a shielding of the cables as
signal wire
to supplement the information
provided in this data sheet, use the
manuals and other documentations
which are available at address
www.cometsystam.com
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Arexx BS-1400GPRS User manual
-
Amprobe TMD-55, TMD-55W & TMD-56 Multilogger Thermometers User manual
-
Arexx RPT-700 User manual
-
Omega Engineering HH806AW User manual
-
-
Omega HH806AW Owner's manual
-
-
-
-
