Note:
The doors, trunk lid, and fuel filler
door will lock, and the beep will
activate at the current volume (if the
beep is currently set to not activate, it
will not activate).
The setting changes when the lock
button on the key fob is pushed, and
the beep will activate at the set volume
(if the beep sound has been set to not
activate, it will not activate).
Complete changing the setting by doing
the following:
Placing the ignition in ACC or ON
position.
Closing the driver's door.
Opening the trunk lid.
Not operating the key fob for ten
seconds.
Pushing any button, except the lock
button on the key fob.
Pushing a request switch on the
exterior door handle.
Note: Refer to “Lock/Unlock With
Advanced Keyless Entry Function — If
Equipped” in “Doors” for further
information.
The operation indicator light flashes
when the buttons are pushed.
Key Fob Buttons
Lock Button
To lock the doors, trunk lid, and fuel
filler door, push the lock button on the
key fob. The hazard warning lights will
flash once and a beep will sound.
Unlock Button
To unlock the doors and trunk lid, push
the unlock button on the key fob, and
the hazard warning lights will flash
twice.
The system can be set to unlock both
doors. Use the following procedure to
change the setting:
1. Place the ignition in the OFF position
and close the doors and trunk lid.
2. Open the driver's door.
3. Within 30 seconds of opening the
driver's door, push and hold the unlock
button on the key fob for five seconds.
Note: The sound of the doors
locking/unlocking can be heard. After
this, the system will change the setting
when the unlock button is pushed (the
sound of the doors locking/unlocking
can be heard).
The setting change can be completed
by doing any one of the following:
Placing the ignition in the ACC or ON
position.
Closing the driver’s door.
Opening the trunk lid.
Not operating the key fob for ten
seconds.
Pushing any button except the
unlock button on the key fob.
Pushing a request switch on the
exterior door handle.
Trunk Button
To open the trunk lid, push and hold the
trunk button until the trunk lid opens.
Panic Button
To turn the Panic Alarm on or off, push
and hold the Panic button on the key
fob and release. When the Panic Alarm
is on, the headlights will turn on, the
park lights will flash, the horn will pulse
on and off, and the turn signal lights will
flash.
Note: The panic button will work if the
doors or trunk are opened or closed.
Turning On The Alarm
Pushing the panic button for one
second or more will trigger the alarm for
about two minutes and thirty seconds,
and the following will occur:
The horn sounds intermittently.
The hazard warning lights flash.
15