GEV CVB 88320 User manual

Brand: GEV

Model: CVB 88320

Category: Split-system air conditioners

Type: User manual

GEV CVB 88320 is a 2-family house video door intercom with a 16-polyphonic ringtone and 102 mm diagonal screen size. It features a splash-proof outdoor unit with a rain cover and automatic loudness control, door opener, and camera monitoring function with infrared light.

Typ: CVB

# 088320

03/2014 UW

Max. 14 Ct./Min aus dem deutschen Festnetz.

Mobil max. 42 Ct./Min.

International calls may vary.

Gutkes GmbH

Rehkamp 13

30853 Langenhagen

Germany

www.gev.de

service@gev.de

Hotline: +49 (0)180/59 58 555

1234

140 cm

150 cm

40°

70°

4 5

1 2

1234

1 2 3 4

Schaltplan/Wiring

diagram

1 Audio/Video/Strom 1 Audio/Video/Power

2 Erde 2 Ground wire

A Außeneinheit/Outdoor unit

B Türöner/Electric lock

C Verteiler/Distributor

D Zusätzliche Inneneinheit/

Add. indoor unit

usätzliche Inneneinheit/

Add. indoor unit

usätzliche Inneneinheit/

Add. indoor unit

Distributor CVB 88528

Monitor 1 Monitor 2 Monitor 3

ED F

2 21 1 21 21

Lock1

Lock2

DC 15V

Troubleshooting

Problem Check point

No power

(no picture on monitor)

• Isthepowersupplyconnectedcorrectly?

Power is on, but no picture on the

monitor

• Isthecablermlyconnectedbetweenthemonitorandthe

camera?

• Isthepolarityofwirescorrectbetweentheoutdoorcamera

unitandindoormonitorunit?

The picture is too dark or white • Adjustbrightnesscontrol

Chime sound is too low • Adjustthevolumecontrol

buttons with wet hands. To clean the monitor or the

camera, do not use cleaning agents. Simply use a

damp cloth. Do not install the camera and the indoor

unit in occurrence of direct light. Do not install near

electronic devices (TV, Computer, telephones), as

this may lead to disturbances of the system.

Recycling instructions

This device may not be disposed of with

unsorted household waste. Owners of old

devices are required by law to dispose of this

device correctly. Contact your town council for

further information.

installing the indoor unit in the now mounted wall

acket. Then plug the cable of the power supply

into the monitor and then the AC adapter into the wall

outlet (Fig. B2).

Installation of the outdoor unit

Lettering of the nameplate

Remove the rain cover: First loosen the screw on the

bottom side (Fig. C1). Then loosen the four screws on

the now exposed backside of the camera unit (Fig.

C2). Now you can lift the cover. You now have the

ability to remove the nameplate and to label it (Fig.

C3). Loosen carefully the rear of the nameplate with an

appropriate screwdriver. Then snap back into place.

Screw the device back together. We recommend a

mounting height of the outdoor unit of about 140 cm

to 170 cm but this can vary depending on your own

circumstances (Fig. C4). Make sure that you do not

expose the unit directly to the weather (e.g. direct

rain). Avoid placing it in direct sunlight. Before the ﬁnal

assembly, ensure that the indoor and the outdoor unit

are wired correctly and are operational. Please also

note the maximum distance between the individual

elements (see point „Connection“).

To install the outdoor unit on the wall, ﬁrst screw the

rain cover as shown in Fig. C5 onto the wall. Before

ﬁnishing the wall mounting, connect the cables to the

outdoor unit according to the wiring diagram (or see

section „Connection“). Now hook the camera module

in the rain cover and attach the device with the screw

on the bottom.

Connection

Included with the video door entry kit CVB 88320 is

a two-pin adapter cable that you need to connect

with your existing installation cable (not supplied).

For distances between indoor and outdoor unit up to

50 m use at least 2 x 0, 5 mm² cable. Connect the

adapter cable to the monitor (Fig. A18).

Connecting the outdoor unit (Fig. D).

Connect the terminals of the outdoor unit 1 and 2 with

the corresponding lines 1 and 2 of the indoor unit (see

wiring diagram). Connect the outdoor unit with a door

opener (not supplied) (Fig. D). Connect terminals 3

and 4 of the outdoor unit with the door opener.

Connect the power supply to the monitor’s designated

end of the power supply with the „+“ and “-“marked

terminals. If you need a door opener, we recommend

from our range Order no. 007680/007642 (110 mm) or

007697/007666 (250 mm).

Activation/Operation

By pressing the call button (Fig. A5), an acoustic

signal is triggered at the indoor units and the monitors

turn on. You can speak with the guest by brieﬂy

pressing on the talk button (Fig. A13). The talking

time is approximately 120 seconds. You can end the

conversation at any time by pressing again the talk

button. Without user activity the panel automatically

switches to stand-by mode after about 40 seconds.

Press the door opener button (Fig. A12) in order to

open the door. By pressing the monitoring function

(Fig. A11) you can monitor at any time the area

covered by the camera. After about 40 seconds the

system switches back in stand-by mode. You can

adjust the brightness (Fig. A15) and contrast (Fig.

A16) of the screen, by adjusting the control dial.

Between the 16 polyphonic ringtones you select by

pressing the ringtone selection button (Fig. A10).

The same applies for the volume control (Fig. A9).

Conﬁrm your entries each with a press of the talk

button (Fig. A13).

Expansion options

You can operate in this system up to 3 indoor

units (order no.: 088481). Furthermore you need a

distributor (order no.: 088528) (Fig. F).

Other Notes

Do not install the indoor units where they are

exposed to high temperatures and humidity or

in the vicinity of TV sets. Do not touch the sensor

In this Set

1 Rain cover

1 Indoor unit

1 Wall mount bracket for internal unit

1 External power supplies

1 Outdoor unit

Screws

1 Four-pole adapter cable

Key assignment/Controls

Outdoor unit (Fig. A)

1 Microphone

2 Infrared light

3 Camera

4 Speaker

5 Doorbell buttons

6 Nameplates

7 Terminal

Indoor Unit (Monitor) (Fig. A)

8 Microphone

9 Volume adjustment

10 Ringtone selection button

11 Monitoring function on/o

12 Door opener button

13 Talk button

14 Speaker

15 Brightness button

16 Contrast control

17 Speaker volume

Connection elements

18 Connection terminal for external power supply

19 Wire connector

Features

2-Family house video door intercom with 16

polyphonic ringtones and 102 mm diagonal screen

size. Splashproof outdoor unit with rain cover and

automatic loudness control, door opener and camera

monitoring function with infrared light. Manually

adjustable call, ringer, brightness and contrast

volume.

Safety instructions

Under no circumstances does the warranty cover

damage resulting from failure to observe

these instructions. Nor do we accept liability

for any indirect damage. Similarly, we can

accept no liability for any material damage

or bodily injury caused by mishandling or failure to

observe the safety instructions. In these cases, no

warranty claim may be made. In addition, for safety

and compliance reasons, you are not authorised to

dismantle or alter the device in any way.

Installation

If in any doubt, rather than mounting, connecting or

installing the equipment yourself, contact a qualiﬁed

technician.

Installation of the indoor unit (Monitor)

Attach the wall mount bracket with the three provided

screws to your intended site (Fig. B1). Make sure

that all cable connections are already wired before

1 Apartment Video Door Entry System CVB 88320

(2-Wire installation)

Technical and design features may be subject to change without notice.

Technical information CVB 88320

Indoor unit (88481) Speciﬁcations

Supply voltage DC 15 V

Rated power operation max 10 W

Stand-by < 0.1 W

Monitor TFT-LED 102 mm diagonal screen size

Resolution 320 x 240 pixels

Operating temperature -5 °C to 40 °C

Mounting method surface mounted

Dimensions approx. W 125 x H 190 x D 26 mm

Power Supply (for each indoor monitor) Speciﬁcations

Input voltage 230 V~, 50 Hz

Output voltage DC 15 V

Rated current 1.2 A

Outdoor Unit (8832001) Speciﬁcations

Camera CCD sensor > 420 TV lines

Operating temperature -20 °C to +50 °C

Mounting method surface mounted

Door opener max. 12 V/1.0 A

Dimensions approx. W 85 x H 142 x D 38 mm

GEV CVB 88320 User manual

Brand: GEV

Model: CVB 88320

Category: Split-system air conditioners

Type: User manual

Download PDF

report

GEV CVB 88320 User manual

GEV CVB 88320 User manual

Other documents