2. KitchenAid
  3. KRLB 1211
KRLB 1211

KitchenAid KRLB 1211 Program Chart

  • Hello! I am an AI chatbot trained to assist you with the KitchenAid KRLB 1211 Program Chart. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Product sheet
3
Product sheet
1
9
4
2
3
A
1
2
B
6
5
8
7
10
3
A. Refrigerator compartment
1. Crisper drawer
2. Shelves / Shelf area
3. Light bulb or LEDs box (depending on model)
4. Meat/Fish compartment (if present)
5. Upper door tray
6. Door trays
7. Bottle rack
8. Bottle holder (if provided)
9. Rating plate (at the side of crisper drawer)
10. Electronic control group
B. Freezer compartment
1. Ice cube tray (inside compartment)
2. Freezer compartment inner door
Note: The number of shelves and type of accessories may vary, depending on the model.
All shelves, door trays and racks are removable.
Important: Refrigerator accessories must not be washed in a dishwasher.
The meat/fish compartment lid must not be washed with water but cleaned with a damp
sponge.
4
Refrigerator compartment controls
AB
C
led 1led 2led 3led 4
A. Temperature adjustment key (change the temperature setting in a cyclical manner)
B. Appliance on/off switch
C. Set temperature display LED:
• LED 1: lowest temperature
• LED 2 or 3: intermediate temperature
• LED 4: highest temperature
• All LEDs on: fast cooling function active
We recommend to set the temperature to an intermediate position
The refrigerator is designed to operate at ambient temperatures between +10°C and +32°C. Optimum
performance is achieved at temperatures between +16°C and +32°C.
Note: Ambient temperature, frequency of door opening and position of the appliance can affect the
temperatures inside the refrigerator, and therefore also those of the meat & fish compartment. It is
therefore recommended that the temperature setting is adjusted based on these factors.
5
Always disconnect the refrigerator from the power
supply before replacing any light bulb. If the inside light
is not working, it is necessary to:
1. Remove the light cover: put the fingers into the side
ventilation holes (1), stretch the cover gently and
move it upwards.
2. Remove the bulb pulling it out of the holder (do not
rotate).
3. Check the bulb and replace (if necessary) by pushing
its terminals into the holder sockets until it stops.
4. Replace the light cover or holder.
The appliance is equipped with a special push-in light bulb.
This bulb is available only from our After-Sales Service.
The bulb should not exceed 15W.
Do not leave the bulb uncovered.
Replacing the light bulb
5019 708 01021
Printed in Italy
11/08
GB
/