7 After 20 seconds, repeat step 7 until you achieve the desired look.
8 To straighten the rest of your hair, repeat steps 4 to 7.
3 Create flicks and curls
To create icks: ( )
1 Straighten a section of hair and turn the straightener half-circle inwards
(or outwards) when it reaches the end of the hair.
2 Hold the straightener in same position for 2 to 3 seconds, and then
release it.
To create curls: (
)
Note: Do not clamp the hair ends between the straightening plates and
wind the hair around the plates.
1 Take a section of hair (max. 5cm) and place it between the straightening
plates fairly close to the scalp.
2 Turn the straightener 180 degrees inwards until the section forms
a U-shape, so that the Thermo-protected curved surface (
) can
cools down the curls for long-lasting results..
3 Slide the straightener slowly downwards in a single motion to the end,
and then turn the straightener inwards. The slower the movement, the
tighter the curl; the faster the movement, the looser the curl.
4 Hold the straightener in same position for 2 to 3 seconds, and then
release it.
5 After 20 seconds, repeat steps 1-4 until you achieve the desired look.
Tip: It is normal if the appliance produces some smoke when you use
it for curling.
After use:
1 Switch off the appliance and unplug it.
2 Place it on a heat-resistant surface until it cools down.
3 Clean the appliance and straightening plates by damp cloth.
4 Keep it in a safe and dry place, free of dust. You can also hang it with
the hanging loop (
), or store in the heat-resistant pouch supplied.
