Hobart CSD Chemical Sensing Device Operating instructions

Brand: Hobart

Model: CSD Chemical Sensing Device

Type: Operating instructions

Hobart CSD Chemical Sensing Device is a reliable tool designed to detect the presence or absence of liquid chemical in tubes, aiding in the efficient management of chemical dispensing systems in warewashers. With LED indicators and audible alarms, it ensures that the appropriate chemicals are available for optimal cleaning and sanitization. Furthermore, the device allows for the disabling and reactivating of sensors, providing flexibility in chemical usage and customization to specific needs.

Operate the chemical dispensing pumps (refer to

machine operating manual) to make sure that chemical

liquid is present in the tubing going through the sensors

in the device. LED indicator lights come on

continuously when machine comes on to indicate that

liquid chemical is present in the tube(s).

A flashing indicator light and a periodic audible alarm

indicate that liquid chemical has been depleted and

needs to be replenished.

Keep sufficient chemical supplies on hand to replenish

as necessary.

If one or more chemicals are not going to be used, the system can be set so that the related sensor

is disabled. To disable the sensor, press the appropriate button until the light goes off. To

reactivate a disabled sensor, make sure liquid chemical is present in the tubing and press the

appropriate button again until the light turns on.

To Recalibrate Sensors

If the Chemical Sensing Device does not indicate the presence or absence of liquid chemical

properly, it may be necessary to recalibrate the sensor by disabling and then reactivating the

sensor. To disable the sensor, press the appropriate button until the light goes off. To reactivate

a disabled sensor, make sure liquid chemical is present in the tubing and press the appropriate

button again until the light turns on. If sensor is enabled while tube is empty, device may not

operate properly. If the Chemical Sensing Device does not indicate the presence or absence of

liquid chemical properly, contact your local Hobart Service office.

SUPPLEMENT TO INSTRUCTIONS MANUAL —

Model LT1 Warewasher, ML-104239

Model SR24C Warewasher, ML-130021, ML-27872

Model SR24H Warewasher, ML-130022, ML-27873

CHEMICAL SENSING DEVICE

SAVE THESE INSTRUCTIONS

GENERAL

The Chemical Sensing Device senses the presence of liquid chemical in a tube as it passes

through a sensor. This device is standard on model LT1 and SR24C warewashers built after

January 1, 2005, and is an option on model SR24H warewashers built after January 1, 2005.

OPERATION

CHEMICAL SENSING DEVICE (Fig. 1)

FORM 35388 (Dec. 2004)

701 S. RIDGE AVENUE

TROY, OHIO 45374-0001

937 332-3000

www.hobartcorp.com

HOLD TO

ENABLE / DISABLE FLASHING – NO CHEMICAL

ON - CHEMICAL

OFF – DISABLED

DETERGENT

LED's

Supplement to FORMS:

18500 Rev.A,

35309 Rev.A

RINSE AID

SANITIZER

Fig. 1

Hobart CSD Chemical Sensing Device Operating instructions

Hobart CSD Chemical Sensing Device Operating instructions

Hobart CSD Chemical Sensing Device Operating instructions

Related papers

Other documents