13 US-EN
Press the M+ button 9 to save the measured
weight along with the nutritional and energy
values. The measurement save display 12
will
show ΣM XX. XX will be represented as a 2 digit
number, i.e., ΣM 01.
After saving the weight along with the nutritional
and energy values, remove the food and then
place another food on the weighing surface 1 .
Proceed in the same way to save the weight of
the food and the corresponding nutrient and
energy values. The weight, nutritional and energy
values are increased by one after each save. The
numbers from the last weighing are displayed for
4 seconds.
NOTE: The memory can store up to 99
measurements. To be able to save further
measurements, delete the saved data by pressing
the MC button 8 .
Important: All previously saved measured
values are deleted after pressing the
MC button 8 .
NOTE: If the total for a saved weight, nutritional
or energy value exceeds the maximum value, the
corresponding display 11
, 17
will show “0-Ld”.
“ΣM” and the 2 digits from the last process both
flash to indicate that no further measurements can
be saved. The following maximum values apply:
Weight: 99:15.9 lb’oz /
999.95 oz / 99.999 kg
PROT (protein): 352.73 oz / 9999.9 g
FAT (fat): 352.73 oz / 9999.9 g
CARB (carbohydrates): 352.73 oz / 9999.9 g
BE (bread units): 999.99
KJ (kilojoules): 99999
KCAL (kilocalories): 99999
CHOL (cholesterol): 0.352 oz / 9999.9 mg
Displaying added measured
values
You can call up added measured values at any time.
Press the MR button 4 . The totals of all saved
the measured values will appear in the display
11
, 17
for 10 seconds.
If you do not press any other buttons for 10
seconds, the product will go back to weighing.
Deleting measured values
Press the MC button 8 if you wish to delete
the saved measured values. All saved measured
values will then be deleted.
Saving your own food codes
NOTE: You can assign a code to other foods and
save their nutritional and energy values in the spare
memory entries 800 - 999 (empty at delivery). The
nutritional and energy values you enter each refer to
100 g of food.
NOTE: You can find the nutritional values of
foods on their individual packaging or in specialist
literature.
Switch on the product by pressing the ON/OFF
button 6 . The LC display 2 will show all the
displays for 2 seconds.
Press the MR button 4 and UNIT button 7
simultaneously for 3 seconds until “CODE 800”
flashes in the food code display 13
.
To save the nutritional and energy values of the
new food enter a code between 800 and 999 by
pressing the number buttons 3 .
The following five nutritional and energy values
will neede to be set for each new food:
• PROT (protein)
• FAT (fat)
• CARB (carbohydrates)
• KCAL (kilocalories)
• CHOL (cholesterol)