2. CEM
  3. EDGE Side Enclosure

CEM EDGE Side Enclosure User guide

  • Hello! I've reviewed the EDGE Side Enclosure Guide. This document describes the proper use of the side enclosure for CEM's EDGE system, which is designed to provide a clean environment for lab work. I'm ready to answer your questions about its operation and features, specifically regarding the correct positioning of the enclosure during various procedures.
  • When should the Side Enclosure be in the up position?
    When should the Side Enclosure remain in the down position?
    How do you lower the Side Enclosure?
EDGE® Side Enclosure Guide Page 1 of 2
www.cem.com © 2020 CEM Corporation
All rights reserved. This may not be reproduced or published without written permission from CEM.
EDGE Side Enclosure
The EDGE Side Enclosure offers a clean environment for labs processing air monitoring or PFAS samples or high traffic labs in need of
a clean space for extractions. Please contact your local sales representative if you have a Side Enclosure that has not been installed. If
you do have an installed Side Enclosure, follow the directions below for proper use.
EDGE® Side Enclosure Guide Page 2 of 2
© 2020 CEM Corporation
To access the rack area, use the handle of the Side Enclosure to raise it until the bottom of the enclosure can slide into the grooves.
The Side Enclosure should only be up while inserting/removing the rack or Q-Cups.
The Side Enclosure must remain in the down position while the EDGE is running. When ready to run, lower the Side Enclosure by
raising it above the grooves it is sitting in using its handle and gently setting it into place at the bottom of its frame.
/