2
For 4 way cassette
Bolt(M5XL35 MACHINE)
(4)
Installation manual
(1)
Accessories
1. Open the electrical component box cover.
After untightening the screws, slide the electrical component box
cover in the direction of the arrow as shown in the gure and pull it
down.
If the supplied bolt is lost, you may purchase M5 machine bolt (with length of the thread more than 20mm long) and a circular washer
from any retail hardware store to replace the lost bolt.
2. Pull both hooksin thedirectionof carved arrows and take the grille
to open.
Hooks are located below the Samsung logo on the grille.
PULL
PULL
3
ENGLISH
4. Detach the 4 corners of the panel. Use two grooves on the each
corner of the panels when pulling them out.
Handle the corner with digital display gently, since there are electrical
cables connected to that corner.
Each corner portion of the panel is easy for you to adjust the height,
but a special tool should be used. Don’t use directly hand.
3. Install the panel using 2 hooks on the both sides of the indoor unit.
Groove
5. Fix the bolt to the panel.
1) Fix 4 bolts to the panel temporarily.
2) Fix them tightly not to make a gap between the panel and the ceiling.
6. Connect 3 cables between the indoor unit and the panel.
Make sure you check the number of pins on the two white terminal
before connecting the cables.
Hook
Adjustment of the indoor unit
height from the holes in the corner
of panel is possible.
Pipe connecting area is not
allowed to adjustment of the
indoor unit height .
NOTE
Panel
White(13 PIN)
White(10 PIN)
Blue
4
8. Attach and close the front grille.
Make sure the hooks on the rear side of grille ts properly into the
grooves on panel () and then push the panel to close ().
9. Check out that the panel is xed to the indoor unit.
Fix screws tightly between the panel and the surface of the ceiling.
If the panel is installed incorrectly, air may leak.
Do not block any discharge vents in the panel.
7. Close the electrical component box cover and tighten the screws.
Grille
Hook
For 4 way cassette
• If the angle on the air ow blades has been changed by user due to opening the front grille for installation or
maintenance, you must turn o the circuit breaker and turn it on again before using the air conditioner.
Otherwise, angles of the each angle can be dierent or some of the blade may not close when the product is o.
NOTE
ENGLISH
5
AA
Memo
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in countries with separate collection systems)
This marking on the product, accessories or literature indicates that the product and its electronic accessories (e.g.
charger, headset, USB cable) should not be disposed of with other household waste at the end of their working life. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate these
items from other types of waste and recycle them responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this product, or their local government
office, for details of where and how they can take these items for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the purchase contract. This
product and its electronic accessories should not be mixed with other commercial wastes for disposal.
(For India only)
For more information on safe disposal and recycling, visit our website www.samsung.com/in/support or contact our
Helpline number - 1800 40 SAMSUNG (1800 40 7267864)
1800 5 SAMSUNG (1800 5 7267864)
AEEE Yönetmeliğine Uygundur
This product is India RoHS compliant.
Panel (Mini-4 way cassette type)
Air Conditioner
installation manual
imagine the possibilities
Thank you for purchasing this Samsung product.
DB68-03638A-03
/