CHAUVET DJ JAM Pack Diamond Reference guide

Quick Reference Guide

JAM Pack Diamond QRG EN

2

About This

Guide

The JAM Pack Diamond

Quick Reference Guide (QRG) has basic product

information such as mounting and operation. Download the

User Manual

from www.chauvetlighting.com for more details.

Disclaimer

The information and specifications contained in this QRG are subject to

change without notice.

Safety Notes

These Safety Notes include important information about

installation, use,

and maintenance.

• This product is not intended for permanent installation.

• ONLY connect this product to a grounded and protected circuit.

• Always disconnect from power before cleaning.

• DO NOT look at the light source when the product is on.

• Make sure the power cord is not crimped or damaged.

• Never disconnect this product from power by pulling on the cord.

• When mounting this product overhead, use a safety cable.

• DO NOT allow flammable materials close to the unit while operating.

• DO NOT touch this product when it is operating because it may be hot.

• The voltage of the outlet to which you are connecting this product must

be within the range stated on the decal or rear panel of the product.

• This product is for indoor use only! (IP20) To prevent risk of fire or

shock, do not expose this product to rain or moisture.

• Always mount this product in a location with adequate ventilation, at

least 20 in (50 cm) from adjacent surfaces.

• Be sure that no ventilation slots on the unit’s housing are blocked.

• Never connect this product to a dimmer or rheostat.

• ONLY use the hanging/mounting bracket or the handles to carry this

product.

• The maximum ambient temperature is 104 °F (40 °C). Do not operate

this product at higher temperatures.

• In the event of a serious operating problem, stop using immediately.

• DO NOT open this product. It contains no user-serviceable parts.

• To eliminate unnecessary wear and improve the lifespan, during periods

of non-use completely disconnect the product from power via breaker

or by unplugging it.

• Do not use the fog machine for space heating purposes.

• Use only CHAUVET water-based fog fluid.

• Drain the tank of the fog machine before transporting the product.

FCQ (Fog Cleaner Quart) was specifically developed by Chauvet to

clean your fog machine. Make sure you use FCQ regularly, no longer

than 90 days between cleanings, to increase the life of your product.

JAM Pack Diamond QRG EN

3

Contact

Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux contact

your distributor to request support or return a product. Visit

www.chauvetlighting.com for contact information.

What Is

Included

• UV Strobe Combo

• Mushroom

• Fog Machine

• CHAUVET Fog Fluid (FJP)

•

Permanently Wired Remote

• IRC-6 Remote Control

• 2 External Power Supply Adapters

• Power Cord

• Warranty Card

•

Quick Reference Guide

To Begin

Unpack your JAM Pack Diamond

and make sure you have received all

parts in good condition. If the box or contents appear damaged, notify the

carrier immediately, not Chauvet.

Product

Description

The JAM (Just Add Music) Pack Diamond is a

party in a box. Perfect for

parties, dorm rooms, or any get together. The pack includes:

• A UV wash and strobe combo - a blacklight strip with the ability to

strobe bright white while maintaining a cool UV wash effect. You can

manually change the speed of the strobe, set it to Automatic, or

Sound-Active modes.

• A compact fog machine that emits thick bursts of water-based fog to

enhance any light show. A pint of water-based fog fluid is included for

immediate usability.

• A Mushroom, a mainstay derby effect fixture, can cover an entire room

with crisscrossing beams from floor-to-ceiling and wall-to-wall. The

red, green and blue LEDs produce nearly limitless combinations

through preprogrammed auto or sound modes.

JAM Pack Diamond QRG EN

4

Overview

UV

Strobe Combo

Overview

Fog

Machine

Overview

Mushroom

Back Panel View

Front View

DC Power In

Sound

Sensitivity

Microphone

IR Sensor

Indicator LED

Control Panel

Buttons

Front View

Back Panel View

Nozzle

Fluid Line

Fog Fluid

Tank Cover

Wired Remote

Fog Fluid Level

Indicator

Power In

Fuse Holder

Front View

Back Panel View

IR Sensor

Sound

Sensitivity

DC Power In

Microphone

Safety Loop

JAM Pack Diamond QRG EN

5

External DC

Power

The JAM Pack Diamond UV strobe combo and mushroom products have

external auto-ranging power supplies that can w

ork with an input voltage

range of 100 to 240 VAC, 50/60 Hz.

To eliminate unnecessary wear and improve its lifespan, during periods

of non-

use completely disconnect the product via breaker or by

unplugging it.

Fog Machine

AC Power

The JAM Pack Diamond

fog machine has a fixed voltage power supply and

it can work with an input voltage of 120 VAC at 60 Hz.

The listed current rating indicates the product’s average current draw under

normal conditions.

Always connect the product to a protected circuit (circuit breaker or

fuse). Make sure the product has an appropriate electrical ground to

avoid the risk of electrocution or fire.

Always replace a blown fuse with a fuse of the same type and rating.

Never connect the product to a rheostat (variable resist

or) or dimmer

circuit, even if the rheostat or dimmer channel serves only as a 0 to

100% switch.

Fog Machine

Fuse

Replacement

1. Disconnect the fogger from power.

2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.

3. Pry the safety cap out of the housing.

4. Remove the blown fuse from the clip on the front of the safety cap and

replace with a fuse of the exact same type and rating.

5. Re-insert the fuse holder and reconnect power.

The product does not ship with a spare fuse; however, the saf

ety cap has

room for a spare.

JAM Pack Diamond QRG EN

6

IRC-6 Remote (Infrared Remote Control)

The JAM Pack Diamond UV strobe combo and mushroom product

s are compatible with the

IRC-6 remote from Chauvet.

The following IRC-6 buttons are used with the JAM Pack Diamond:

Turns LEDs on/off

Selects Sound-Active mode

Start/stop strobing (0–20 Hz)

Selects Automatic mode

Speed of strobe, up or down

Static Red

Static Green

Static Blue

Turns the UV on/off for UV strobe

Turns white on/off for UV strobe

o

Red/Green/Blue

o

Green/Blue

o

Red

o

Blue

o

Red/Green

o

Red/Blue

o

Red/Green

o

Red/Blue

o

Green

o

Red/Green

All other buttons on the remote have no function with this product.

The IRC-

6 will not respond to any inputs when Black Out is activated. If the

remote does not r

espond when a button is pressed, try pressing <BLACK OUT>.

You may have inadvertently activated Black Out.

From a distance, all products will respond to the IRC-

6 remote simultaneously

when in close proximity to each other. To select an individual produc

t, the remote

must be aimed only at the desired product.

JAM Pack Diamond QRG EN

7

UV Strobe

Combo

Control

Panel

Description

Button Function

Controls the Strobe mode.

Turns the UV blacklight on or off.

• Indicator LED will blink when Strobe mode is on

• Indicator LED will be static on when in Sound-Active mode

UV Strobe

Combo

Strobe Modes

Function LED Status

Strobe

Modes

Very Fast (20–30 Hz)

Blink

Fast (10–20 Hz)

Blink

Medium (5–10 Hz)

Blink

Slow (1–5Hz)

Blink

Very Slow (0.5–1 Hz)

Blink

Off

Static On

Sound-Active Mode

Static On

Fog Machine

Wired Remote

Trigger the fog machine

using the included wired remote. The LED indicator

on the remote indicates when the fogger has reached the required operating

tem

perature. Press the button on the remote to momentarily output fog. The

length of the wired remote cable is 13 ft (4 m).

JAM Pack Diamond QRG EN

8

Mounting

Before mounting this product, read the Safety Notes. The JAM

Pack

Diamond products can be surface

mounted, but if you choose to mount

overhead using the mounting hole;

do this with a screw, nut and bolt, or a

hanging clamp. When rigging, consider IR function.

UV Strobe

Combo

Mounting

Diagram

Fog Machine

M

ounting

Diagram

Mushroom

M

ounting

Diagram

Suspended

Surface Mounting

Mounting

Clamps

Surface Mounting

Suspended

Surface

Mounting

Feet

Surface

Mounting

Feet

Mounting

Clamps

Suspended

Mounting

Clamps

Surface Mounting

Safety Cable

Page is loading ...

JAM Pack Diamond QRG Multi-Language

Contact

Us

USA WORLD HEADQUARTERS

General Information

Address: 5200 NW 108th Avenue

Sunrise, FL 33351

Voice: (954) 577-4455

Fax: (954) 929-5560

Toll free:(800) 762-1084

Technical Support

Voice: (954) 577-4455 (Press 4)

Fax: (954)

7

56-8015

Email: tech@chauvetlighting.com

W

orld Wide Web

www.chauvetlighting.com

EUROPE.

General Information

Address: Stokstraat 18

9770 Kruishoutem

Belgium

Voice: +32 9 388 93 97

Technical Support

Email: Eutech@chauvetlighting.eu

Wo

rld Wide Web

www.chauvetlighting.eu

General Information

Address: Unit 1C

Brookhill Road Industrial Estate

Pinxton, Nottingham, UK

NG16 6NT

Voice: +44 (0)1773 511115

Fax: +44 (0)1773 511110

Technical Support

Email: uktech@chauvetlighting.com

W

orld Wide Web

www.chauvetlighting.co.uk

MEXICO

General Information

Address: Av. Santa Ana 30

Parque Industrial Lerma

Lerma, Mexico C.P. 52000

Voice: +52 (728) 285-5000

Technical Support

Email: servicio@chauvet.com.mx

W

orld Wide Web www.chauvet.com.mx

Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux, contact the dealer of

record. Follow their instructions to request support or to return a product. Visit our

website for contact details.

JAM Pack Diamond QRG Rev. 1 ML9

Printed in the P. R. C.

CHAUVET DJ JAM Pack Diamond Reference guide

Related papers

Other documents