Page 2 For technical questions, please call 1-888-866-5797. Item 56901
IMPORTANT SAFETY INFORMATION
Assembly Precautions
1. Assemble only according to these instructions.
Improper assembly can create hazards.
2. Wear ANSI-approved safety goggles and
rubber gloves during assembly.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the area during assembly.
5. Do not assemble when tired or when under the
influence of alcohol, drugs or medication.
Use Precautions
1. This product is not a toy. Do not allow
children to play with or near this item.
2. Use as intended only.
3. Inspect before every use; do not use
if parts are loose or damaged.
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
1. Unplug Drain Cleaner from outlet.
Note: Bauer 1724E-B shown in illustrations.
2. Set the Drain Cleaner’s Lock Ring
indicator to the unlock position.
Unlock position
Lock Ring
indicator
Lock Ring
3. Remove six screws from front housing and carefully
front housing from rear housing. Save screws.
F
F
0
R
R
R
Drum
Front
Housing
4. Pull Drum, with cable attached, from front
housing. Place Drum bottom on protected
flat surface with cable pointing up.
5. Pull old cable out of Drum until connection
to Drum Cable is accessible. Stop when
you see the port connection.
6. Carefully remove screw by turning it
counter clockwise. Save screw.
7. Separate cable from Drum Cable.
8. Feed connector end of the Replacement
Cable through the front of the Lock Ring
and through Front Housing, then connect
Replacement Cable to Drum Cable.
9. Make sure the screw hole lines up and attach
the saved screw. Turn screw clockwise
and tighten until the screw head is slightly
lower than the rim of the screw hole.
Port Connection
Screw