Yealink CTP18 User manual

Brand: Yealink

Model: CTP18

Type: User manual

www.yealink.com

Quick Start Guide (V1.0)

English | 简体中文

CTP18

Collaboration Touch Panel

1

CTP18 Connection

Connect your CTP18

Reset

MAC

SN

VC200

PoE

B

or

Video Conferencing Endpoint （except VC200)

Note:

The CTP18 supports 48V/0.27A PoE supply.

Make sure of the connectivity between the CTP18 and endpoint. Otherwise, the

CTP18 may not work properly.

You can also connect the CTP18 to the VCM34, and then connect to the power

and wired network.

If the VC Hub/Phone port of the endpoint is used, you can connect the CTP18

to the PoE switch for power supply and connect to the wireless access point

provided by the endpoint.

A

2

CTP18 Installation

Put on a table

You can place the system on the conference room table and adjust the touch

screen as you need.

28°

50°

Assemble your CTP18

Reset

MAC

SN

1

2

34

Reset

MAC

SN

VCH

3

Start to Use the CTP18

After connected to the power and network, the CTP18 starts automatically.

The CTP18 synchronizes the configurations from the endpoint and goes to

the Home page. From the Home page, you can configure the ndpoint via

the CTP18. For more information, refer to the user guide.

Mount on a Wall

1

33

100mm

If the conference room environment allows, you can also route the CTP18

through the wall.

4

22

55

6

1
2
3
4

Yealink CTP18 User manual

Brand: Yealink

Model: CTP18

Type: User manual

Related papers

Other documents