PEM2201 / 23.04.2021
Recommended installation heights
DIP Switch Settings
Wall mounting height (m)
Ceiling mounted detection pattern (m) Wall mounted detection pattern (m)
Ceiling mounted height (m)
4
9
0
5
4
0
10%
10%
30%
30%
75%
75%
50%
50%
Detection Area
Sensor sensitivity can be adjusted by selecting the combi-
nation on the DIP switches to t precisely for each specic
application. Note: by choosing “Sensor OFF”, it becomes
an ordinary driver without occupancy detection.
I – 100%
II – 75%
III – 50%
IV – Sensor OFF
100%
75%
50%
Sensor OFF
1 2
Hold Time
Select the DIP switch conguration for the light on-time
after presence detection. This function is disabled when
natural light is sucient. Note: this function is disabled
when the natural daylight exceeds the daylight threshold
IV setting for more than 5 minutes.
I – 5s
II – 30s
III – 3min
IV – 10min
5s
30s
3min
10min
43
I
II
II I
IV
Daylight
Set the level according to the xture and environment.
The light will not turn on if ambient lux level exceeds the
daylight threshold preset.
I – Disable
II – 50Lux
III – 10Lux
IV – 5 Lu x
Disable
50Lux
10Lux
5Lux
5 6
Stand-by Period
This is the time period you would like to keep at the low
light output level before it is completely switched o in
the long absence of people. Note: “0s” means on/o con-
trol; “+∞” means the stand-by period is innite and the
light is eectively controlled by the daylight sensor, o
when natural light is sucient and automatically on at
dimming level when insucient.
I – 0 s
II – 10s
III – 30min
IV – +
0s
10s
30min
87
I
II
III
IV +
Stand-by Dimming Level
The setting is used to select the desired dimmed light level
used in periods of absence for enhanced comfort and safety.
30%
10%
9
I
II
I – 10 %
II – 30%
7 / 9
