INSTALLATION SHEET
AT68010
All-Terior LED Wall Sconce
START FROM HERE
1a. 1b. 1c. 1d. 2a. 2b. 2c.
2d.
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all times during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required.
• 120V input
Remove the fixture from its original packaging. Remove
the mounting plate (1c) from within the canopy backplate
(2a) by loosening the four set screws (2d) and two screws
(2b). Secure the mounting plate (1c) to the junction box
(1a) with screws (1d) provided in the hardware package.
1.
2.
3. FOR OUTDOOR OPTION ONLY
To prevent moisture from entering the outlet box and
causing a short, seal around the top and side perimeter
between the fixture and the wall surface with weather
resistant caulking (see Illustration 1). The space at bottom
should be left un-caulked to prevent moisture build-up.
Illustration 1
caulking
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20210713
4a.
Attach the canopy backplate (2a) to the mounting plate
(1c), which is attached to the electrical junction box (1a)
on the wall. First, make proper electrical connections
(black to hot “L”, white to neutral “N”, ground to “GND”)
with wire nuts (1b) provided in hardware package and
place driver (4a) in canopy (2c). Now direct the canopy
backplate (2a) onto the mounting plate (1c) be sure to line
up the mounting threaded holes with the screws (2b).
Next, place the canopy (2c) onto the canopy backplate
(2a) and secure with all four set screws (2d).
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Kuzco Lighting WS19707 User manual
-
Kuzco Lighting EW6208 User manual
-
Kuzco Lighting Lyra TR10022 User manual
-
kuzcolighting EW7024 LED Exterior Wall Sconce User manual
-
Kuzco Lighting Cumulus FM80736 User manual
-
Kuzco Lighting FM11414 User manual
-
Kuzco Lighting FM3511 User manual
-
Kuzco Lighting 402601 User manual
-
aLora LP348148 Installation guide
-
Kuzco Lighting PD80736 User manual
