1. Using an 8mm T-Handle or Socket, remove the two bolts shown in (FIG 1). You will reuse these bolts. Keep track of which one
goes where, the further forward bolt is slightly longer.
2. Line up the Enduro Engineering Ignition Wire Guard to the two bolt holes you removed in step 1. Using the same bolts removed
in step one. Thread them in one at a time and leave loose until both bolts are started. (FIG 2)
3. Using an 8mm T-Handle or Socket, tighten both Ignition Wire Guard Bolts. (FIG 3)
4. Have fun and enjoy your next ride.
SHERCO IGNITION WIRE GUARD
INSTALLATION INSTRUCTIONS
PART NUMBER 27-9013
