There should be no abnormal noise or vibration, the carbon brushes spark should be small and uniform, and the com-

mutator must have a dark brown and uniform strip.

1.6. - Replace the motor, reconnect and reassemble.

NOTE: Do not attempt to repair the motor, send for service.

2. - TO REPLACE THE ON-OFF SWITCH

2.1. - Follow steps 1.1 to 1.3.

2.2. - Disconnect the two leads from the switch.

Remove the three screws and remove the cover top, replace the on-off switch, reconnect and reassemble.

3. - TO REPLACE THE LINE CORD

3.1. - Follow steps 1.1 to 1.3.

3.2. - Remove and replace the new line cord and reassemble as initially placed.

4. - TO REPLACE THE FLOAT

NOTE: Drawing numbers are for identification purposes only.