(145) GENERIC TYPE-A INFLATABLE MANUAL ENGLISH 4.875” X 6.5” 09/09/2019
145
SAVE THESE INSTRUCTIONS
2.
Thegroundsurfacemustbecompactedandfirmenoughtowithstandthe
pressure and weight of a fully set up pool.
Do Not set up the pool on mud, sand,
soft or loose soil condition, deck, platform, concrete, asphalt or any other hard
surfaces.
3.
Pool fencing laws may affect this product. Consult your local council and set up
this product accordingly.
4.
CertaintypesofgrasssuchasSt.AugustineandBermuda,maygrowthroughthe
liner. Grass growing through the liner it is not a manufacture defect.
5.
Theareashallfacilitatedrainageofthepoolwateraftereachuseand/orforlong
term pool storage.
Barriers for Residential Swimming Pool Guidelines:
Anoutdoorswimmingpool,includinganinground,aboveground,orongroundpool,hot
tub,orspa,shouldbeprovidedwithabarrierwhichcomplieswiththefollowing:
1.
Thetopofthebarriershouldbeatleast48inchesabovegrademeasuredonthesideof
thebarrierwhichfacesawayfromtheswimmingpool.Themaximumverticalclearance
between grade and the bottom of the barrier should be 4 inches measured on the side of
thebarrierwhichfacesawayfromtheswimmingpool.Wherethetopofthepoolstructure
is above grade, such as an aboveground pool, the barrier may be at ground level, such
asthepoolstructure,ormountedontopofthepoolstructure.Wherethebarrieris
mounted on top of the pool structure, the maximum vertical clearance between the top of
the pool structure and the bottom of the barrier should be 4 inches.
2.
Openingsinthebarriershouldnotallowpassageofa4-inchdiametersphere.
3.
Solid barriers, which do not have openings, such as a masonry or stone wall, should not
contain indentations or protrusions except for normal construction tolerances and tooled
masonry joints.
4.
Wherethebarrieriscomposedofhorizontalandverticalmembersandthedistance
between the tops of the horizontal members is less than 45 inches, the horizontal
members should be located on the swimming pool side of the fence. Spacing between
verticalmembersshouldnotexceed1-3/4inchesinwidth.Wheretherearedecorative
cutouts,spacingwithinthecutoutsshouldnotexceed1-3/4inchesinwidth.
5.
Wherethebarrieriscomposedofhorizontalandverticalmembersandthedistance
between the tops of the horizontal members is 45 inches or more, spacing between
verticalmembersshouldnotexceed4inches.Wheretherearedecorativecutouts,
spacingwithinthecutoutsshouldnotexceed1-3/4inchesinwidth.
6.
Maximummeshsizeforchainlinkfencesshouldnotexceed1-1/4inchsquareunlessthe
fence is provided with slats fastened at the top or the bottom which reduce the openings
tonomorethan1-3/4inches.
7.
Wherethebarrieriscomposedofdiagonalmembers,suchasalatticefence,the
maximumopeningformedbythediagonalmembersshouldbenomorethan1-3/4
inches.
8.
AccessgatestothepoolshouldcomplywithSectionI,Paragraphs1through7,and
should be equipped to accommodate a locking device. Pedestrian access gates should
open outward, away from the pool, and should be self-closing and have a self latching
device. Gates other than pedestrian access gates should have a self-latching device.
Wherethereleasemechanismoftheself-latchingdeviceislocatedlessthan54inches
fromthebottomofthegate,(a)thereleasemechanismshouldbelocatedonthepool
sideofthegateatleast3inchesbelowthetopofthegateand(b)thegateandbarrier
shouldhavenoopeninggreaterthan1/2inchwithin18inchesofthereleasemechanism.
9.
Whereawallofadwellingservesaspartofthebarrier,oneofthefollowingshouldapply:
Page 3