Work-pro CS 30 A User manual

Type
User manual

Work-pro CS 30 A is a 30W speaker with a 12 cm dynamic cone speaker. It has a frequency response of 125~15000 Hz and a sound pressure level of 101 dB/W/m. The speaker has an impedance of 330 ohms and can be used with 50V, 70V, or 100V lines. The speaker also has a built-in transformer that allows you to change the impedance to 8 ohms.

Work-pro CS 30 A is a 30W speaker with a 12 cm dynamic cone speaker. It has a frequency response of 125~15000 Hz and a sound pressure level of 101 dB/W/m. The speaker has an impedance of 330 ohms and can be used with 50V, 70V, or 100V lines. The speaker also has a built-in transformer that allows you to change the impedance to 8 ohms.

Changing lmpedance
PRECAUTIONS
These speakers are not suitable for mouting on a car.
Do not install these speakers with their front upward to prevent malfunctions.
When using more e than 2 speakers in the same place, pay careful attentfions to hte polality matching.
To change the preset impedance, follow the procedures below
30W (Preset impedance: 330 ohm)
6W (Preset impedance: 1.65 k ohm)
BROWN
RED
ORANGE
GRAY
WHITE
83
165
330
670
1.3k
---
---
---
15W
3.8W
7.5W
30W
70V
7.5W
15W
3.8W
1.9W
30W
50V
30W
7.5W
30W
100V
15W
Transformer tap
CAUTION
causes damage to the speaker.
the impedance table since this
to positions marked " - " on
Never connect transformer taps
30W(A)
When using the high impedance.According to input power label (on the input cable) to connect the
input line of desired input impedance.
When using low impedance (8 ). detach the black and white transformer lead cables conected to
the speaker unit.
Then detach the black and white input cables connected to transformer taps, and connect the black
and white input cables to (- ) and (+) terminals of the speaker unit respectively.
Surely insulate the detached transformer lead cables with friction tape so as not to contact other part.
-- ++
When using the high impedance.According to input power label (on the input cable) to connect the
input line of desired input impedance.
When using low impedance (8 ). detach the black and white transformer lead cables conected to
the speaker unit.
Then detach the black and white input cables connected to transformer taps, and connect the black
and white input cables to (- ) and (+) terminals of the speaker unit respectively.
Surely insulate the detached transformer lead cables with friction tape so as not to contact other part.
-- ++
4
1
3
2
0
Transformer lead cables
White
(+)
Black
(- )
lnput cable
Note: lmpedances are indicated on the transformer.
Note: lmpedances are indicated on the transformer.
Transformer lead cables
White
(+)
Black (- )
lnput cable
5
2
1
4
3
0
Dimensiones (mm)
Cambio De Impedancia
40.0
195.5
256.0
36.0
3-Æ13.0
49.0
49.0
292.0
35.0
49.0
49.0
206.0
3-Æ13.0
199.5
133.0
40.0
180.0
178.0
228.0
209.0
117.0
314.0
283.0
234.0
154.0
271.0
6W
30W
transformador
" "
Nunca conecte el transformador a las posiciones
Precaución
6W
MARRON
ROJO
NARANJA
GRIS
BLANCO
1.65 k 6.0W 3.0W 1.50W
6.7 k 1.5W 0.38W0.75W
830
---
3.0W6.0W
420
--- ---
6.0W
70V 50V100V
3.3 k 0.75W1.50W3.0W
transformador
(100V Iinea)
MARRON
ROJO
3.3 k (3W)
3W
10 k (1W)
6W(A)
125~15000 Hz
1.4 kg
A : 3.7 kg
150~15000 Hz
98 dB/W/m
101 dB/W/m
6W (50V, 70V, 100V Linea)
12 cm Altavoz cono Dinamico
30W (50V, 70V, 100V Linea)
330 ohm
420 ohm (50V Linea)
830 ohm (50V, 70V Linea)
1.65 k ohm, 3.3 K ohm
1.65 k ohm
MODELO
lmpedancia por defecto
Respuesta de Frecuencia
Nivel presión sonora
Peso
Impedancia de Entrada
Altavoz Incorporado
Nivel de Potencia de entrada
Especificaciones sujetas a cambio sin previo aviso.
cables de transformador
cable de entrada
Nota: La impedancia está indicada en el transformador.
0 1 2
Blanco (+)
Negro (- )
- +-- ++
Blanco (+)
Negro (- )
cable de entrada
0
5
1
4
2
3
cables del
transformador
- +-- + +
OHMIOS
marcadas como ya que podría causar
daños al altavoz
Nota: La impedancia está indicada en el transformador.
6.7 k ohm
OHMS
CS 6A - CS 30A User Manual/Manual de uso Page 1
CS 6A - CS 30A User Manual/Manual de uso Page 4
This symbol on the product or on its packaging indicates that this product
shall not be trated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical an electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste handling
of this product. The recycling of amterials will help to conserve natural
resources. For more detailed information sabout recycling of this product,
please contact your local city office, your household waste disposal service
or the shop where you purchased the product.
1.3k ohm , 330 ohm
83 ohm (50V Linea)
165 ohm (50V, 70V Linea)
670 ohm
  • Page 1 1
  • Page 2 2
  • Page 3 3

Work-pro CS 30 A User manual

Type
User manual

Work-pro CS 30 A is a 30W speaker with a 12 cm dynamic cone speaker. It has a frequency response of 125~15000 Hz and a sound pressure level of 101 dB/W/m. The speaker has an impedance of 330 ohms and can be used with 50V, 70V, or 100V lines. The speaker also has a built-in transformer that allows you to change the impedance to 8 ohms.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages