Trendnet TEG-S811FI Quick Installation Guide

Type
Quick Installation Guide
H/W: v1.0R
TEG-S811Fi
Quick Installation Guide
Ðóññêèé
1
1. ×òî íóæíî ñäåëàòü â ñàìîì íà÷àëå
Ñîäåðæèìîå óïàêîâêè
Ïðèìåíåíèå
?
?
?
?2 êðåïåæíûå ñêîáû ñ âèíòàìè
?
?
CD-ROM-äèñê
Ðóêîâîäñòâî ïî áûñòðîé
óñòàíîâêå
Îäèí êàáåëü RS-232
Îäèí ñåòåâîé ïðîâîä
TEG-S811Fi
?
? Êîìïüþòåð ñ ïîñëåäîâàòåëüíûì ïîðòîì
? Ìíîãîìîäîâûé âîëîêîííî-îïòè÷åñêèé êàáåëü 50/125 èëè 62.5/125 µm
ñ ðàçúåìàìè òèïà SC äëÿ ïîðòîâ 100BaseFX.
?Ìîäóëü Mini-GBIC (íàïð., . TEG-MGBSX, TEG-MGBS10, TEG-MGBS40,
TEG-MGBS80, TEG-MGBS10D3_D5, TEG-MGBS40D3_D5) äëÿ ãíåçä
Mini-GBIC.
Âåá-áðàóçåð: Internet Explorer (6.0 èëè áîëåå ïîçäíåé âåðñèè)
1000MbpsFiber 10/100Mbps
8-Port 10/100Mbps Layer 2 Managed Switch
with Gigabit Port and Mini-GBIC Slot
(TEG-S811Fi)
24-port Gigabit Web Smart Switch
with Mini-GBIC slots
(TEG-240WS)
Multi-Mode Fiber
Mini-GBIC Modules
(TEG-MGBSX)
RS-232
Laptop with PC Card
(TE100-PCBUSR)
Workstation with PCI Adapter
(TE100-PCIWA)
Workstation
8-Port 100Base-FX Layer 2
Managed Switch with Mini GBIC Slot
(TEG-S081FMi)
5
Troubleshooting
Q1:
A1:
After connecting the TEG-S811Fi to a power outlet, the LEDs do not turn on.
Check the connection of the power cord to the TEG-S811Fi and the power outlet. Also
check that the power outlet is receiving power.
Q3:
A3:
I connect the switch to my network via the mini-GBIC module, but I am unable to make a
connection.
First, verify that you are using the proper fiber cable. Second, verify that the TX and RX
cables have been reverse on the opposite Fiber connection. Third, when connecting to the
mini-GBIC modules, your Fiber connection must be Gigabit. Fourth, power down the switch.
Wait 15 seconds, then plug the switch back in.
Q4:
A4:
How do I login to the switch via the console port?
Follow the instructions below:
1) Connect the RS-232 cable from a serial port on your Windows PC to the console port on
your computer.
2) Go to Start -> Programs -> Accessories -> Communications -> Hyperterminal
3) Enter a name, select an icon and then click OK.
4) Select the correct COM port (e.g. COM1, COM2) and then click OK.
5) Enter the following, click Apply and then click OK:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
6) Press Enter.
7) Enter the user name and password. By default, the user name and password is root.
Please refer to the User's Guide for a list of commands.
If you still encounter problems or have any questions regarding the TEG-S811Fi, please contact
TRENDnet’s Technical Support Department.
Q2: How do I configure TCP/IP settings on my computer?
1. Go into the Control Panel and double-clic the Network
Connections icon, right-click the Local Area
Connection icon and then click Properties.
2. Click Internet Protocol (TCP/IP) and then click
Properties. Then click on Use the following IP
address, and make sure you assign your network
adapter an IP address in the subnet of 192.168.16.x.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.
Copyright ©2008. All Rights Reserved. TRENDnet.
20675 Manhattan Place
Torrance, CA 90501
USA
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com/register
Customer Support
Email:
Europe (Germany France Italy Spain Switzerland UK)
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Worldwide
Telephone: +(31) (0) 20 504 05 35
Toll Free Telephone: +00800 60 76 76 67
. . . . .
Visit www.trendnet.com/support
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Trendnet TEG-S811FI Quick Installation Guide

Type
Quick Installation Guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI